LP3873, LP3876
www.ti.com
SNVS220E –NOVEMBER 2002–REVISED APRIL 2013
LP3873/LP3876 3A Fast Ultra Low Dropout Linear Regulators
Check for Samples: LP3873, LP3876
1
FEATURES
DESCRIPTION
The LP3873/LP3876 series of fast ultra low-dropout
linear regulators operate from a +2.5V to +7.0V input
supply. Wide range of preset output voltage options
are available. These ultra low dropout linear
regulators respond very quickly to step changes in
load, which makes them suitable for low voltage
microprocessor applications. The LP3873/LP3876 are
developed on a CMOS process which allows low
quiescent current operation independent of output
load current. This CMOS process also allows the
LP3873/LP3876 to operate under extremely low
dropout conditions.
2
•
•
•
•
•
•
Ultra Low Dropout Voltage
Low Ground Pin Current
Load Regulation of 0.08%
1µA Quiescent Current in Shutdown Mode
Ensured Output Current of 3A DC
Available in DDPAK/TO-263 and TO-220
Packages
•
•
•
•
•
•
Output Voltage Accuracy ± 1.5%
Error Flag Indicates Output Status
Sense Option Improves Load Regulation
Minimum Output Capacitor Requirements
Overtemperature/overcurrent Protection
−40°C to +125°C Junction Temperature Range
Dropout Voltage: Ultra low dropout voltage; typically
80mV at 300mA load current and 800mV at 3A load
current.
Ground Pin Current: Typically 6mA at 3A load
current.
APPLICATIONS
Shutdown Mode: Typically 1µA quiescent current
when the shutdown pin is pulled low.
•
•
•
•
•
•
•
•
Microprocessor Power Supplies
GTL, GTL+, BTL, and SSTL Bus Terminators
Power Supplies for DSPs
SCSI Terminator
Error Flag:Error flag goes low when the output
voltage drops 10% below nominal value.
SENSE: Sense pin improves regulation at remote
loads.
Post Regulators
High Efficiency Linear Regulators
Battery Chargers
Precision Output Voltage: Multiple output voltage
options are available ranging from 1.8V to 5.0V with
an ensured accuracy of ±1.5% at room temperature,
and ±3.0% over all conditions (varying line, load, and
temperature).
Other Battery Powered Applications
Typical Application Circuits
*SD and ERROR pins must be pulled high through a 10kΩ pull-up resistor. Connect the ERROR pin to ground if this
function is not used. See Application Hints for more information.
1
Please be aware that an important notice concerning availability, standard warranty, and use in critical applications of
Texas Instruments semiconductor products and disclaimers thereto appears at the end of this data sheet.
All trademarks are the property of their respective owners.
2
PRODUCTION DATA information is current as of publication date.
Products conform to specifications per the terms of the Texas
Instruments standard warranty. Production processing does not
necessarily include testing of all parameters.
Copyright © 2002–2013, Texas Instruments Incorporated