Ordering number : ENN 7143
CMOS IC
LC72311W, 72312W, 72313W
Low-Voltage ETR-Controller
Preliminary
Overview
•
A/D converter:
Four-input 8-bit converter
The LC72311W, LC72312W, and LC72313W are
low-voltage single-chip FM/AM electronic tuning
microcontrollers that include a built-in PLL circuit for
frequencies up to 230 MHz, a 1/4 duty 1/2 bias LCD
controller, and a small EEPROM. These microcontroller
also provide a low-power standby mode that reduces power
consumption by switching the system clock frequency.
Furthermore, since these devices include a low-pass filter
amplifier required for the electronic tuning system and a
tuning voltage generator circuit, they can contribute to
reduced end product costs through lower parts counts.
These ICs are optimal for use in low-voltage portable audio
equipment that includes a radio receiver.
•
Input ports:
9 or 10 ports (Ports PA, PF, and HCTR)
The PF port is shared with the A/D converter, and HCTR
is shared with the IF counter.
•
Output ports:
8 ports (Ports PB and PE)
PE3 is shared with the BEEP pin, PE0 to PE2 are
open-drain ports, and the PB port can be switched to
function as an open-drain port.
Continued on next page.
Package Dimensions
unit: mm
Functions
•
Program memory (ROM):
3220-SQFP80
8192 × 16 bits (16 KB) LC72311W
16,384 × 16 bits (32 KB) LC72312W
24,576 × 16 bits (48 KB) LC72313W
[LC72311W, 72312W, 72313W]
14.0
12.0
•
Data memory (RAM):
0.135
512 × 4 bits (RAM)
512 × 4 bits (EEPROM)
1.25
1.25
0.5
60
41
61
40
•
Cycle time:
0.71 µs (at 4.2336 MHz) (All 1-word instructions)
40 µs (at 75 kHz) (All 1-word instructions)
•
Stack: 8 levels
•
LCD driver:
21
80
48 to 96 segments (1/4 duty 1/2 bias drive)
1
20
•
Interrupts:
0.2
Two external interrupt systems
Internal timer interrupts: two systems (1,5,10, and 50 ms)
Serial I/O interrupt (SIO0 only)
0.5
0.5
SANYO: SQFP80
■ Any and all SANYO products described or contained herein do not have specifications that can handle
applications that require extremely high levels of reliability, such as life-support systems, aircraft’s control
systems, or other applications whose failure can be reasonably expected to result in serious physical and/or
material damage. Consult with your SANYO representative nearest you before using any SANYO products
described or contained herein in such applications.
■ SANYO assumes no responsibility for equipment failures that result from using products at values that exceed,
even momentarily, rated values (such as maximum ratings, operating condition ranges, or other parameters)
listed in products specifications of any and all SANYO products described or contained herein.
N3001RM(OT)No.7143-1/9