Ordering number : ENN7737
Monolithic Linear IC
LA8580W
Compander + I/O Switching Telephone Audio
Signal-Processing IC
• Built-in electronic volume control (about 2 dB per step
over 15 steps) and extensive set of level switching
circuits allow this IC to easily switch signals with a wide
range of levels.
• A compander circuit, which provides noise reduction
during communication, is built in. This circuit can also
be used for noise suppression and improved audio
quality in wireless communication systems.
• Built-in splatter filter (fifth order Butterworth filter with
settable center frequency) for reduced parts counts.
Overview
The LA8580W is an I/O switching audio signal-
processing IC for low-power cordless telephone base sets.
It also supports personal fax machines for the Japanese
domestic market. It integrates an extensive set of
functions, including a compander, a crosspoint switch for
I/O switching, an electronic volume control, and level
switching, ALC, VOX, and filter circuits.
Applications
Low-power cordless telephone base sets and Japanese
market home fax machines.
Package Dimensions
unit: mm
Functions
3190A-SQFP64 (0.5 mm lead pitch)
• Crosspoint switch (equivalent to 10 × 9) and electronic
volume control (VOL)
[LA8580W]
12.0
10.0
• Audio level switching (ATT) for the telephone circuit
system, the handset system, both DSP systems, the
doorphone system, and the microphone system
• Dedicated ring-tone input pin (OSC-IN), ring-tone level
switching (OSC-ATT), ring-tone muting (OSC-SW)
• ALC amplifier, audio level detection (VOX),
operational amplifiers for the DSP I/O filters.
• Compressor, limiter (IDC), compressor system muting,
splatter filter.
48
33
49
32
17
64
1
16
0.18
0.15
(0.5)
(1.25)
• Expander, receive system input filter amplifier, and
expander system muting
• Receive system data waveform shaping (with threshold
follower on/off function)
• Serial interface (8-bit serial data input)
SANYO: SQFP64
Features
• Includes a 10 input system/9 output system crosspoint
switch that supports mixing. Systems that provide
flexible and complex switching of signal paths can be
implemented easily.
Any and all SANYO products described or contained herein do not have specifications that can handle
applications that require extremely high levels of reliability, such as life-support systems, aircraft’s
control systems, or other applications whose failure can be reasonably expected to result in serious
physical and/or material damage. Consult with your SANYO representative nearest you before using
any SANYO products described or contained herein in such applications.
SANYO assumes no responsibility for equipment failures that result from using products at values that
exceed, even momentarily, rated values (such as maximum ratings, operating condition ranges, or other
parameters) listed in products specifications of any and all SANYO products described or contained
herein.
SANYO Electric Co.,Ltd. Semiconductor Company
TOKYO OFFICE Tokyo Bldg., 1-10, 1 Chome, Ueno, Taito-ku, TOKYO, 110-8534 JAPAN
32204TN (OT) No. 7737-1/26