DATASHEET
Automotive 5A Synchronous Buck Regulator
ISL78235R5668
The ISL78235R5668 is a highly efficient, monolithic,
Features
• 2.7 to 5.5V input voltage range
synchronous step-down DC/DC converter that can deliver 5A
continuous and up to 8A pulsed output current from a 2.7V to
5.5V input supply. The device uses peak current mode control
architecture to achieve very low duty cycle operation at high
frequency with fast transient response and excellent loop stability.
• 5A continuous; 8A pulse output current operation
• 2MHz default switching frequency
• 100ns guaranteed phase minimum on-time for wide output
regulation
• Adjustable switching frequency from 500kHz to 4MHz
• External synchronization from 1MHz to 4MHz
• Optional PFM mode for light-load efficiency improvement
• Very low ON-resistance HS/LS switches: 35mΩ/11mΩ
• Internal 1ms or adjustable external soft-start
• Soft-stop output discharge during disable
• OTP, OCP, output OVP, input UVLO protections
• 1% reference accuracy over-temperature
• Up to 95% efficiency
The ISL78235R5668 integrates a low ON-resistance P-channel
(35mΩ, typical) high-side FET and N-channel (11mΩ, typical)
low-side FET to maximize efficiency and minimize external
component count. The 100% duty cycle operation allows less
than 250mV dropout voltage at 5A output current. The
operating frequency of the Pulse Width Modulator (PWM) is
adjustable from 500kHz to 4MHz. The default switching
frequency of 2MHz is set by connecting the FS pin high.
The ISL78235R5668 can be configured for discontinuous
(PFM) or forced continuous (PWM) operation at light load.
Forced continuous operation reduces noise and RF
interference, while discontinuous mode provides higher
efficiency by reducing switching losses at light loads.
• AEC-Q100 qualified
Fault protection is provided by internal hiccup mode current
limiting during short-circuit and overcurrent conditions. The
device also integrates output overvoltage and
over-temperature protections. A power-good monitor indicates
when the output is in regulation. The ISL78235R5668 offers a
1ms Power-Good (PG) timer at power-up.
Applications
• Automotive infotainment power
• DC/DC point-of-load modules
• μC/µP, FPGA and DSP power
• Video processor/SOC power
• Li-ion battery powered devices
When in shutdown, the ISL78235R5668 discharges the output
capacitor through an internal 100Ω soft-stop switch. Other
features include internal fixed or adjustable soft-start and
internal/external compensation.
Related Literature
• ISL78235 Datasheet
The ISL78235R5668 is available in a 3mmx3mm 16 Ld Thin
Quad Flat No-lead (TQFN) Pb-free package with an exposed pad
for improved thermal performance. The ISL78235R5668 is
rated to operate across the temperature range of -40°C to
+85°C.
L
100
V
OUT
5A LOAD
DSP, FPGA
2.7V TO 5.5V
C
OUT
90
80
C
IN
16 15 14
13
PGND
PGND
SGND
FB
VIN
V
= 1.2V; T = -40°C
1
2
3
4
12
11
10
9
OUT
70
60
VDD
PG
ISL78235R5668
V
= 1.2V; T = +25°C
OUT
V
= 1.2V; T = +105°C
OUT
SYNC
50
40
6
7
8
5
0
1
2
3
4
5
6
7
8
OUTPUT LOAD (A)
FIGURE 1. TYPICAL APPLICATION: 5A BUCK REGULATOR
FIGURE 2. EFFICIENCY vs LOAD (V = 5V)
IN
January 21, 2016
FN8769.1
CAUTION: These devices are sensitive to electrostatic discharge; follow proper IC Handling Procedures.
1-888-INTERSIL or 1-888-468-3774 | Copyright Intersil Americas LLC 2015, 2016. All Rights Reserved
Intersil (and design) is a trademark owned by Intersil Corporation or one of its subsidiaries.
All other trademarks mentioned are the property of their respective owners.
1
5秒后页面跳转
STM32H743技术深度剖析与应用案例探索
LM321中文资料解析：引脚功能介绍、技术特点、技术特性分析
74HC14芯片资料介绍：性能特性分析、引脚介绍
LM1875芯片手册：功放参数分析、引脚说明、电路设计要点
微信公众号
抖音公众号
浙公网安备 33010502006866号 浙ICP备10014259号-119
营业执照ICP证
数据手册
如果您发现信息不准确，
