5秒后页面跳转
ISL6569CB PDF预览

ISL6569CB

更新时间: 2024-01-14 19:46:41
品牌 Logo 应用领域
英特矽尔 - INTERSIL 多相元件控制器
页数 文件大小 规格书
22页 492K
描述
Multi-Phase PWM Controller

ISL6569CB 技术参数

是否无铅: 不含铅是否Rohs认证: 符合
生命周期:Obsolete零件包装代码:QFN
包装说明:HVQCCN, LCC32,.2SQ,20针数:32
Reach Compliance Code:compliantECCN代码:EAR99
HTS代码:8542.39.00.01风险等级:5.83
模拟集成电路 - 其他类型:SWITCHING CONTROLLER控制模式:CURRENT/VOLTAGE-MODE
控制技术:PULSE WIDTH MODULATION最大输入电压:5.25 V
最小输入电压:4.75 V标称输入电压:5 V
JESD-30 代码:S-PQCC-N32JESD-609代码:e3
长度:5 mm湿度敏感等级:3
功能数量:1端子数量:32
最高工作温度:70 °C最低工作温度:
封装主体材料:PLASTIC/EPOXY封装代码:HVQCCN
封装等效代码:LCC32,.2SQ,20封装形状:SQUARE
封装形式:CHIP CARRIER, HEAT SINK/SLUG, VERY THIN PROFILE峰值回流温度(摄氏度):260
认证状态:Not Qualified座面最大高度:1 mm
子类别:Switching Regulator or Controllers表面贴装:YES
切换器配置:PHASE-SHIFT最大切换频率:1000 kHz
温度等级:COMMERCIAL端子面层:Matte Tin (Sn)
端子形式:NO LEAD端子节距:0.5 mm
端子位置:QUAD处于峰值回流温度下的最长时间:40
宽度:5 mm

ISL6569CB 数据手册

 浏览型号ISL6569CB的Datasheet PDF文件第2页浏览型号ISL6569CB的Datasheet PDF文件第3页浏览型号ISL6569CB的Datasheet PDF文件第4页浏览型号ISL6569CB的Datasheet PDF文件第5页浏览型号ISL6569CB的Datasheet PDF文件第6页浏览型号ISL6569CB的Datasheet PDF文件第7页 
ISL6569  
®
Data Sheet  
December 29, 2004  
FN9085.7  
Multi-Phase PWM Controller  
Features  
The ISL6569 provides core-voltage regulation by driving two  
interleaved synchronous-rectified buck-converter channels  
in parallel. Interleaving the channel timing results in  
increased ripple frequency which reduces input and output  
ripple currents. The reduction in ripple results in lower  
component cost, reduced dissipation, and a smaller  
implementation area.  
• Multi-Phase Power Conversion  
- 2 Phase Operation  
• Active Channel Current Balancing  
• Precision r  
DS(ON)  
Current Sharing  
- Lossless  
- Low Cost  
The ISL6569 uses cost and space-saving r  
sensing  
• Input Voltage: 12V or 5V Bias  
DS(ON)  
for channel current balance, active voltage positioning, and  
over-current protection. Output voltage is monitored by an  
internal differential remote sense amplifier. A high-bandwidth  
error amplifier drives the output voltage to match the  
programmed 5-bit DAC reference voltage. The resulting  
compensation signal guides the creation of pulse width  
modulated (PWM) signals to control companion Intersil  
MOSFET drivers. The OFS pin allows direct offset of the  
DAC voltage from 0V to 50mV using a single external  
resistor. The reference and amplifiers are trimmed to ensure  
a system accuracy of ±1% over temperature.  
• Precision CORE Voltage Regulation  
- ±1% System Accuracy Over Temperature  
- Differential Remote Output Voltage Sensing  
- Programmable Reference Offset  
• Microprocessor Voltage Identification Input  
- 5-Bit VID Input  
- 0.800V to 1.550V in 25mV Steps  
- Dynamic VIDTM Technology  
• Programmable Droop Voltage  
• Fast Transient Recovery Time  
• Over Current Protection  
Outstanding features of this controller IC include  
Dynamic VIDTM technology allowing seamless on-the-fly VID  
changing without the need of any external components.  
Output voltage “droop” or active voltage positioning is  
optional. When employed, it allows the reduction in size and  
cost of the output capacitors required to support load  
transients. A threshold-sensitive enable input allows the use  
of an external resistor divider for start-up coordination with  
Intersil MOSFET drivers or any other devices powered from  
a separate supply.  
• Digital Soft Start  
• Threshold Sensitive Enable Input  
• High Ripple Frequency (160kHz to 2MHz)  
• QFN Package:  
- Compliant to JEDEC PUB95 MO-220 QFN - Quad Flat  
No Leads - Package Outline  
- Near Chip Scale Package footprint, which improves  
PCB efficiency and has a thinner profile  
Superior over-voltage protection is achieved by gating on the  
lower MOSFET of all phases to crowbar the output voltage.  
Pb-Free Available (RoHS Compliant)  
An optional second crowbar on V , formed with an external  
IN  
MOSFET or SCR gated by the OVP pin, is triggered when  
an over-voltage condition is detected. Under-voltage  
conditions are detected, but PWM operation is not disrupted.  
Over-current conditions cause a hiccup-mode response as  
the controller repeatedly tries to restart. After a set number  
of failed startup attempts, the controller latches off. A power  
good logic signal indicates when the converter output is  
between the UV and OV thresholds.  
Applications  
• AMD Hammer Family Processor Voltage Regulator  
• Low Output Voltage, High Current DC-DC Converters  
• Voltage Regulator Modules  
CAUTION: These devices are sensitive to electrostatic discharge; follow proper IC Handling Procedures.  
1
1-888-INTERSIL or 321-724-7143 | Intersil (and design) is a registered trademark of Intersil Americas Inc.  
Copyright © Intersil Americas Inc. 2002-2004. All Rights Reserved. All other trademarks mentioned are the property of their respective owners.  
Dynamic VID™ is a trademark of Intersil Americas Inc.  

与ISL6569CB相关器件

型号 品牌 获取价格 描述 数据表
ISL6569CB-T INTERSIL

获取价格

Multi-Phase PWM Controller
ISL6569CBZ INTERSIL

获取价格

Multi-Phase PWM Controller
ISL6569CBZ-T ROCHESTER

获取价格

SWITCHING CONTROLLER, 1000 kHz SWITCHING FREQ-MAX, PDSO24, LEAD FREE, PLASTIC, MS-013-AD,
ISL6569CR INTERSIL

获取价格

Multi-Phase PWM Controller
ISL6569CR-T INTERSIL

获取价格

Multi-Phase PWM Controller
ISL6569CRZ INTERSIL

获取价格

Multi-Phase PWM Controller
ISL6571 INTERSIL

获取价格

Complementary MOSFET Driver and Synchronous Half-Bridge Switch
ISL6571CR INTERSIL

获取价格

Complementary MOSFET Driver and Synchronous Half-Bridge Switch
ISL6571CR-T INTERSIL

获取价格

Complementary MOSFET Driver and Synchronous Half-Bridge Switch
ISL6571CRZ INTERSIL

获取价格

Complementary MOSFET Driver and Synchronous Half-Bridge Switch