ISL54205B
®
Data Sheet
September 25, 2007
FN6557.0
MP3/USB 2.0 High Speed Switch with
Negative Signal Handling
Features
• High Speed (480Mbps) and Full Speed (12Mbps)
Signaling Capability per USB 2.0
The Intersil ISL54205B dual SPDT (Single Pole/Double
Throw) switches combine low distortion audio and accurate
USB 2.0 high speed data (480Mbps) signal switching in the
same low voltage device. When operated with a 2.7V to 3.6V
single supply these analog switches allow audio signal swings
below-ground, allowing the use of a common USB and audio
headphone connector in Personal Media Players and other
portable battery powered devices.
• Low Distortion Negative Signal Capability
• Detection of V
BUS
Voltage on USB Cable
• Control Pin to Open all Switches and Enter Low Power
State
• Low Distortion Headphone Audio Signals
- THD+N at 20mW into 32Ω Load . . . . . . . . . . . . . <0.1%
The ISL54205B incorporates circuitry for detection of the USB
• Cross-talk (20Hz to 20kHz) . . . . . . . . . . . . . . . . . . -110dB
V
voltage, which is used to switch between the audio and
BUS
• Single Supply Operation (V ) . . . . . . . . . . . . 2.7V to 3.6V
DD
USB signal sources in the portable device. The part has a
control pin to open all the switches and put the part in a low
power down state.
• -3dB Bandwidth USB Switch. . . . . . . . . . . . . . . . . 630MHz
• Available in µTQFN and TDFN Packages
• Pb-Free (RoHS Compliant)
The ISL54205B is available in a small 10 Ld 2.1mmx1.6mm
ultra-thin µTQFN package and a 10Ld 3mmx3mm TDFN
package. It operates over a temperature range of -40 to
+85°C.
• Compliant with USB 2.0 Short Circuit Requirements
Without Additional External Components
Applications
Related Literature
• Application Note AN1280 “ISL54205EVAL1Z Evaluation
Board User’s Manual.
• MP3 and Other Personal Media Players
• Cellular/Mobile Phones
• PDA’s
• Technical Brief TB363 “Guidelines for Handling and
Processing Moisture Sensitive Surface Mount Devices
(SMDs)”
• Audio/USB Switching
• Application Note AN557 “Recommended Test Procedures
for Analog Switches”
Application Block Diagram
V
DD
µCONTROLLER
ISL54205B
V
BUS
CTRL
LOGIC CIRCUITRY
22kΩ
USB
4MΩ
4MΩ
HIGH-SPEED
D-
COM -
COM +
TRANSCEIVER
D+
50kΩ
50kΩ
L
R
CODEC
GND
CAUTION: These devices are sensitive to electrostatic discharge; follow proper IC Handling Procedures.
1-888-INTERSIL or 1-888-468-3774 | Intersil (and design) is a registered trademark of Intersil Americas Inc.
Copyright Intersil Americas Inc. 2007. All Rights Reserved
1
All other trademarks mentioned are the property of their respective owners.