ISL3871AIK18, ISL3871AIN18
®
Data Sheet
Augus t 2003
FN8078
Wireles s LAN Integrated Medium Acces s
Controller with Bas eband Proces s or
Features
• USB host interface supports USB V1.1 at 12Mbps.
The Intersil ISL3871A Wireless LAN
Integrated Medium Access Controller
with Integrated Baseband Processor
• New Start up modes allow the PCMCIA card information
structure to be initialized from a serial EEPROM. This
allows firmware to be downloaded from the host,
eliminating the parallel flash memory device
is part of the PRISM® 2.4GHz radio chipset. The ISL3871A
directly interfaces with the Intersil’s Zero-IF
QMODEM(ISL3684). Adding Intersil’s Power Amp (ISL3984)
offers the designer a complete end-to-end WLAN chipset
solution. Protocol and PHY support are implemented in
firmware, thus supporting customization of the WLAN
solution.
• Firmware can be loaded from serial flash memory
• Zero glue connection to 16-bit wide SRAM devices
• Low-frequency crystal oscillator to maintain time and allow
baseband clock source to power off during sleep mode
• Improved performance of internal WEP engine
• Improvements to debug mode support tracing execution
from on chip memory
Firmware implements the full IEEE 802.11 Wireless LAN
MAC protocol. It supports BSS and IBSS operation under
DCF, and operation under the optional point coordination
function (PCF). Low level protocol functions such as
RTS/CTS generation and acknowledgment, fragmentation
and de-fragmentation, and automatic beacon monitoring are
handed without host intervention. Active scanning is
performed autonomously once initiated by host command.
Host interface command and status handshakes allow
concurrent operations from multi-threaded I/O drivers.
Additional firmware functions specific to access point
applications are also available.
• Programmable MBUS cycle extension allows accessing of
slow memory devices without slowing the clock
• Complete DSSS baseband processor
• RAKE receiver with decision feedback equalizer
• Processing gain. . . . . . . . . . . . . . . . . . . . . FCC compliant
• Programmable data rate . . . . . . . . . 1, 2, 5.5, and 11Mbps
• Available in two packages:
- Ultra small BGA package. . . . . . . . . . . . . . . . 14x14mm
- Large LQFP for easy board layout
• Modulation methods . . . . . . . .DBPSK, DQPSK, and CCK
• Supports full or half duplex operations
• On-chip A/D and D/A converters for I/Q data, AGC, and
adaptive power control
The ISL3871A has on-board A/D’s and D/A for analog I and
Q inputs and outputs, for which the ISL3684 Zero-IF
QMODEM is recommended. Differential phase shift keying
modulation schemes DBPSK and DQPSK, with data
scrambling capability, are available along with
• Targeted for multipath delay spreads 100ns at 11Mbps,
250ns at 5.5Mbps
• Supports short preamble and antenna diversity
Complementary Code Keying to provide a variety of data
rates. Both Receive and Transmit AGC functions with 7-bit
AGC control obtain maximum performance in the analog
portions of the transceiver.
Applications
• PC Card Wireless LAN Adapters
• USB Wireless LAN Adapters
• PCN/Wireless PBX/Wireless Local Loop
Built-in flexibility allows the ISL3871A to be configured
through a general purpose control bus, for a range of
applications. The ISL3871A is housed in either a thin plastic
BGA package or a TQFP flat pack suitable for PCMCIA
board applications.
• High Data Rate Wireless LAN Systems Targeting IEEE
802.11b Standard
• Wireless LAN Access Points and Bridge Products
• Spread Spectrum WLAN RF Modems
• TDMA or CSMA Packet Protocol Radios
• ISA, ISA PnP WLAN Cards
The ISL3871A is designed to provide maximum
performance with minimum power consumption. External pin
layout is organized to provide optimal PC board layout to all
user interfaces including PCMCIA and USB.
Ordering Information
TEMP.
PACKAGE
o
PART NUMBER RANGE ( C) DESCRIPTION PKG. DWG. #
ISL3871AIK18
-40 to 85
-40 to 85
-40 to 85
-40 to 85
192 BGA
Tape and Reel 1000 Units /Reel
208 LQFP Q208.28x28A
Tape and Reel 500 Units/Reel
V192.14x14
ISL3871AIK18-TK
ISL3871AIN18
ISL3871AIN18-TS
CAUTION: These devices are sensitive to electrostatic discharge; follow proper IC Handling Procedures.
1
1-888-INTERSIL or 321-724-7143 | Intersil (and design) is a registered trademark of Intersil Americas Inc.
Copyright © Intersil Americas Inc. 2003. All Rights Reserved. All other trademarks mentioned are the property of their respective owners.
PRISM® is a registered trademark of Intersil Americas Inc. PRISM and design is a trademark of Intersil Americas Inc.
5秒后页面跳转
解析光耦仿真器：升级光耦合器技术的必要性
英伟达新一代Blackwell GPU过热问题致交付延迟
国产厂商思特威CMOS图像传感器芯片单月出货超1亿颗，技术创新引领行业发展
台积电5nm和3nm产能利用率达100%，半导体行业景气度持续攀升
微信公众号
抖音公众号
浙公网安备 33010502006866号 浙ICP备10014259号-119
营业执照ICP证
数据手册
如果您发现信息不准确，
