HX428C14PBK4/32
32GB (8GB 1G x 64-Bit x 4 pcs.)
DDR4-2800 CL14 288-Pin DIMM
SPECIFICATIONS
CL(IDD)
15 cycles
Row Cycle Time (tRCmin)
46.5ns(min.)
260ns(min.)
Refresh to Active/Refresh
Command Time (tRFCmin)
Row Active Time (tRASmin)
Maximum Operating Power
UL Rating
33ns(min.)
TBD W*
94 V - 0
0o C to +85o C
-55o C to +100o C
Operating Temperature
Storage Temperature
*Power will vary depending on the SDRAM used.
DESCRIPTION
FEATURES
• Power Supply: VDD=1.2V Typical
HyperX HX428C14PBK4/32 is a kit of four 1G x 64-bit (8GB)
DDR4-2800 CL14 SDRAM (Synchronous DRAM) 2Rx8,
memory module, based on sixteen 512M x 8-bit FBGA
components per module. Each module kit supports Intel®
Extreme Memory Profiles (Intel® XMP) 2.0. Total kit
capacity is 32GB. Each module has been tested to run at
DDR4-2800 at a low latency timing of 14-15-15 at 1.35V. The
SPDs are programmed to JEDEC standard latency
DDR4-2133 timing of 15-15-15 at 1.2V. Each 288-pin
DIMM uses gold contact fingers. The JEDEC standard
electrical and mechanical specifications are as follows:
• VDDQ = 1.2V Typical
• VPP - 2.5V Typical
• VDDSPD=2.2V to 3.6V
• Nominal and dynamic on-die termination (ODT) for
data, strobe, and mask signals
• Low-power auto self refresh (LPASR)
• Data bus inversion (DBI) for data bus
• On-die VREFDQ generation and calibration
• Dual-rank
• On-board I2 serial presence-detect (SPD) EEPROM
• 16 internal banks; 4 groups of 4 banks each
• Fixed burst chop (BC) of 4 and burst length (BL) of 8
via the mode register set (MRS)
XMP TIMING PARAMETERS
•JEDEC: DDR4-2133 CL15-15-15 @1.2V
•XMP Profile #1: DDR4-2800 CL14-15-15 @1.35V
•XMP Profile #2: DDR4-2666 CL14-14-14 @1.35V
• Selectable BC4 or BL8 on-the-fly (OTF)
• Fly-by topology
• Terminated control command and address bus
• Height 2.167” (55.05mm), w/heatsink
Continued >>
kingston.com/hyperx
Document No. 4807266-001.B00 04/21/15 Page 1