HV310

更新时间： 2024-01-24 03:51:17

品牌	Logo	应用领域
超科 - SUPERTEX		控制器
页数	文件大小	规格书
6页	79K
描述
Hotswap, Inrush Current Limiter Controllers

阅读下载

中文翻译

获取价格

技术参数
数据手册

如果您发现信息不准确，欢迎纠错

HV310 技术参数

是否Rohs认证：	符合	生命周期：	Lifetime Buy
包装说明：	4.90 X 3.90 MM, 1.75 MM HEIGHT, 1.27 MM PITCH, GREEN, MS-012AA, SOIC-8	Reach Compliance Code：	compliant
Factory Lead Time：	13 weeks	风险等级：	5.69
Base Number Matches：	1

HV310 数据手册

HV300/HV310

Assuming the above conditions are satisfied and while continuing

to hold the PWRGD output inactive and the external MOSFET

GATE voltage low, the current source feeding the RAMP pin is

turned on. The external capacitor connected to it begins to

charge, thus starting an initial time delay determined by the

value of the capacitor. If an interruption of the input power

occurs during this time (i.e. caused by contact bounce) or the

OV or UV limits are exceeded, an immediate reset occurs and

the external capacitor connected to the RAMP pin is discharged.

Functional Description

Insertion Into Hot Backplanes

Telecom, Data Network and some Computer applications require

the ability to insert and remove circuit cards from systems

without powering down the entire system. All circuit cards have

some filter capacitance on the power rails, which is especially

true in circuit cards or network terminal equipment utilizing

distributed power systems. The insertion can result in high

inrush currents that can cause damage to connector and circuit

cards and may result in unacceptable disturbances on the

system backplane power rails.

When the voltage on the RAMP pin reaches an internally set

voltage limit, the gate drive circuitry begins to turn on the

external MOSFET; allowing the current to softly rise over a

period of a few hundred micro-seconds to the current limit set

point. While the circuit is limiting current, the voltage on the

RAMP pin will be fixed.

The HV300/HV310 was designed to allow the insertion of these

circuit cards or connection of terminal equipment by eliminating

these inrush currents and powering up these circuits in a

controlled manner after full connector insertion has been

achieved. The HV300/HV310 is intended to provide this function

on a negative supply rail in the range of -10 to -90 Volts.

Depending on the value of the load capacitance and the

programmed current limit, charging may continue for some

time. The magnitude of the current limit is programmed by

comparing a voltage developed by a sense resistor connected

between the V_EEand SENSE pins to 50mV (Typical). Once the

load capacitor has been charged, the current will drop which

will cause the ramp voltage to continue rising; providing yet

another programmed delay.

Waveforms

When the ramp voltage is within 1.2V of the internally regulated

voltage, the controller will force the GATE full on and will

activate the PWRGD pin and the circuit will transition to a low

power standby mode. The PWRGD pin is often used as an

enable for downstream DC/DC converter loads.

Drain

50V/div

V_IN

50V/div

At any time during the start up cycle or thereafter, crossing the

UV and OV limits (including hysteresis) will cause an immediate

reset of all internal circuitry. Thereafter the start up process will

begin again.

Gate

5.00V/div

I_inrush

500mA/div

5.00ms/div

Operation

On initial power application an internal regulator seeks to provide

10 Volts for the internal IC circuitry. Until the proper internal

voltage is achieved all circuits are held reset, the open drain

PWRGD signal is inactive to inhibit the start of any load circuitry

and the gate to source voltage of the external N-channel

MOSFET is held low. Once the internal under voltage lock out

(UVLO) has been satisfied, the circuit checks the input supply

voltage under voltage (UV) and over voltage (OV) sense circuits

to ensure that the input voltage is within acceptable programmed

limits. These limits are determined by the selected values of

resistors R1, R2 and R3, which form a voltage divider.

1 2 3 456

中文翻译

下载PDF

与HV310相关器件

型号	品牌	获取价格	描述	数据表
HV3-1000-5	RENESAS	获取价格	HV3-1000-5
HV3-1000-7	RENESAS	获取价格	HV3-1000-7
HV3-1000A-5	RENESAS	获取价格	IC,PHASE CONTROL CIRCUIT,DIP,16PIN,PLASTIC
HV3-1000A-7	RENESAS	获取价格	IC,PHASE CONTROL CIRCUIT,DIP,16PIN,PLASTIC
HV310LG	SUPERTEX	获取价格	Hotswap, Inrush Current Limiter Controllers
HV310LG-G	MICROCHIP	获取价格	HV310LG-G
HV310LG-G	SUPERTEX	获取价格	Power Supply Support Circuit, Adjustable, 1 Channel, PDSO8, 4.90 X 3.90 MM, 1.75 MM HEIGHT
HV311	SUPERTEX	获取价格	Hotswap, Controllers with Circuit Breaker
HV311LG	SUPERTEX	获取价格	Hotswap, Controllers with Circuit Breaker
HV311LG-G	MICROCHIP	获取价格	POWER SUPPLY SUPPORT CKT

与HV310相关文章

晶闸管阳极与阴极之间加电压时控制极的电流流动分析
2024-06-05

10
探究MOS管沟道夹断后载流子传输机制及其电路设计影响
2024-06-05

9
光敏电阻的工作原理、作用及检测方法
2024-06-05

8
ENC28J60以太网控制器全面解析：特性、应用、引脚说明
2024-06-05

6

产品中心

服务支持

精选活动

关于我们

帮助中心

HV310

HV310 技术参数

HV310 数据手册

与HV310相关器件

与HV310相关文章

您还可以找

产品中心

服务支持

精选活动

关于我们

帮助中心

HV310

HV310 技术参数

HV310 数据手册

与HV310相关器件

与HV310相关文章

您还可以找

您在本页遇到什么问题？