Datasheet > HO-P-2011

HO-P-2011

更新时间： 2022-12-29 18:28:59

品牌	Logo	应用领域
莱姆 - LEM		/
页数	文件大小	规格书
15页	1338K
描述
Current Transducer

阅读下载

获取价格

数据手册

如果您发现信息不准确，欢迎纠错

HO-P-2011 数据手册

HO 60 .. 250-P series

Absolute maximum ratings

Parameter

Supply voltage (not destructive)

Symbol

Unit

Value

U_C

Supply voltage (not entering non standard modes)

6.5

Primary conductor temperature

T_B

°C

120

ESD rating, Human Body Model (HBM)

U_ESD

Stresses above these ratings may cause permanent damage. Exposure to absolute maximum ratings for extended periods may

degrade reliability.

UL 508: Ratings and assumptions of certiﬁcation

File # E189713 Volume: 2 Section: 5

Standards

● CSA C22.2 NO. 14-10 INDUSTRIAL CONTROL EQUIPMENT - Edition 11 - Revision Date 2011/08/01

● UL 508 STANDARD FOR INDUSTRIAL CONTROL EQUIPMENT - Edition 17 - Revision Date 2010/04/15

Ratings

Parameter

Symbol

Unit

Value

Primary involved potential

V AC/DC

600

Max surrounding air temperature

T_A

°C

105

According to series primary

Primary current

I_P

current

Secondary supply voltage

Output voltage

U_C

V DC

V_out

0 to 5

Conditions of acceptability

1 - These devices have been evaluated for overvoltage category III and for use in pollution degree 2 environment.

2 - A suitable enclosure shall be provided in the end-use application.

3 - The terminals have not been evaluated for ﬁeld wiring.

4 - These devices are intended to be mounted on a printed wiring board of end use equipment. The suitability of the

connections (including spacings) shall be determined in the end-use application.

5 - Primary terminals shall not be straightened since assembly of housing case depends upon bending of the terminals.

6 - Any surface of polymeric housing have not been evaluated as insulating barrier.

7 - Low voltage control circuit shall be supplied by an isolating source (such as a transformer, optical isolator,

limiting impedance or electro-mechanical relay).

10 - The jumper installed within the primary hole is only intended for ﬁxing the sensor and not for carrying the primary current.

Marking

Only those products bearing the UR Mark should be considered to be Listed or Recognized and covered under UL's Follow-Up

Service. Always look for the Mark on the product.

Page 2/15

16July2015/Version 5

LEM reserves the right to carry out modiﬁcations on its transducers, in order to improve them, without prior notice

www.lem.com

123 4 5 6 7...15

下载PDF

与HO-P-2011相关器件

型号	品牌	描述	获取价格	数据表
HO-P-2012	LEM	Current Transducer	获取价格
HO-P-2013	LEM	Current Transducer	获取价格
HO-P-2014	LEM	Current Transducer	获取价格
HO-P-2015	LEM	Current Transducer	获取价格
HO-P-2016	LEM	Current Transducer	获取价格
HO-P-2017	LEM	Current Transducer	获取价格