HIP1015, HIP1016
TM
Data Sheet
May 2000
File Number 4778.1
Power Distribution Controllers
Features
The HIP1015 and HIP1016 are hot swap power controllers.
The HIP1015 is targeted for a +12V bus whereas the
HIP1016 is targeted for +5V applications. Each has an
undervoltage (UV) monitoring and reporting with a threshold
level ~17% lower than the nominal +12V and +5V.
• HOT SWAP Single Power Distribution Control (HIP1015
for 12V, HIP1016 for 5V and Low Side Switch)
• Undervoltage Monitoring and Notification
• Overcurrent Fault Isolation
• Programmable Current Regulation Level
• Programmable Current Limit Time to Latch-Off
The HIP1015 has an integrated charge pump allowing
control of up to a +12V bus using an external N-channel
MOSFET. The HIP1016 can also be used to control much
higher positive or negative voltages in a low side controller
configuration. Both the HIP1015 and HIP1016 feature
programmable Overcurrent (OC) detection, current limiting
regulation with time delay to latch off and soft start.
• Rail to Rail Common Mode Input Voltage Range
(HIP1015)
• Internal Charge Pump Allows the use of N-channel
MOSFET (HIP1015)
• Undervoltage and Overcurrent Latch Indicators
• Adjustable Turn-On Ramp
• Protection During Turn On
Ordering Information
• Two Levels of Overcurrent Detection Provide Fast
Response to Varying Fault Conditions
TEMP.
PKG.
NO.
o
PART NUMBER RANGE ( C)
PACKAGE
• Less Than 1µs Response Time to Dead Short
HIP1015CB
0 to 85
0 to 85
8 Lead SOIC
M8.15
M8.15
HIP1015CB-T
8 Lead SOIC
Tape and Reel
Applications
• Power Distribution Control
HIP1016CB
0 to 85
0 to 85
8 Lead SOIC
M8.15
M8.15
• Hot Plug Components and Circuitry
• High Side Low Voltage (< +15V) Switching
• Low Side High Voltage (> +15V, Negative V) Switch
HIP1016CB-T
8 Lead SOIC
Tape and Reel
Pinout
HIP1015, HIP1016 (SOIC)
TOP VIEW
ISET
ISEN
GATE
VSS
1
2
3
4
8
7
6
5
PWRON
PGOOD
CTIM
VDD
Application One - High Side Controller
Application Two - Low Side Controller
+VBUS
LOAD
+
-
LOAD
1
2
3
4
8
7
6
5
PWRON
PGOOD
HIP1015
OC
HIP1016
PWRON
12V REG
OC
+12V
CAUTION: These devices are sensitive to electrostatic discharge; follow proper IC Handling Procedures.
1-888-INTERSIL or 321-724-7143 | Intersil and Design is a trademark of Intersil Corporation. | Copyright © Intersil Corporation 2000
1