HBL5006 Series
LED Shunt
The HBL5006 Series are electronic shunts which provide a current
bypass in the case of LEDs going into open circuit. LEDs are by nature
quite fragile when subjected to transients and surge conditions. There
are also many cases where high reliability of the LED lighting must be
maintained such as in headlights, lighthouses, bridges, aircraft, runways
and so forth. In these cases the low cost addition of the shunt device will
provide full assurance that an entire string of LEDs will not extinguish
should one LED fail open. The shunt device is also applicable to other
loads where circuit continuity is required. The devices are designed to
be used with LED string currents from 50 to 350 mA.
http://onsemi.com
MARKING
DIAGRAMS
1
2
SOD−323
CASE 477
HD
M
Features
• Protection for the Following IEC Standards:
IEC 61000−4−2 (Level 4)
ISO 10605
1
2
SOD−523
CASE 502
56
• Low ESD Clamping Voltage
• Automatically Resets Itself if the LED Heals Itself or is Replaced
• ON−State Voltage Typically 1.1 V
• OFF−State Current less than 1.0 mA
2
1
SOD−923
CASE 514AB
LD M
• SZ Prefix for Automotive and Other Applications Requiring Unique
Site and Control Change Requirements; AEC−Q101 Qualified and
PPAP Capable
XX
M
= Specific Device Code
= Date Code
• These Devices are Pb−Free and are RoHS Compliant
Typical Applications
HBL5006
• LEDs where Preventive Maintenance is Impractical
• LED Headlights in Automobiles
• Automotive LED Applications
Control
Circuit
• LEDs with High Reliability Requirements
• Crowbar Protection for Open Circuit Conditions
• Overvoltage Protection for Sensitive Circuits
ESD
1
2
+
−
HBL5006
Apply heat sinking to pin 2
ORDERING INFORMATION
See detailed ordering and shipping information in the package
dimensions section on page 5 of this data sheet.
© Semiconductor Components Industries, LLC, 2014
1
Publication Order Number:
August, 2014 − Rev. 0
HBL5006/D