Applications
Genesys™ power supplies are designed for demanding applications.
Common controls are shared across all platforms
Test and Measurement
Last-Setting memory simplifies test design and
requires no battery backup.
Laser Diode
OVP is directly set on Voltage Display, assuring
accurate protection settings.
Built-in RS-232/RS-485 gives maximum system
flexibility along with 0-5V and 0-10V, selectable
analog programming.
Current Limit Fold Back assures load is protected
from current surges.
Heater Supplies
Wide range of available inputs allows testing of many
different devices.
Smooth,reliableencodersenhancefrontpanelcontrol.
Remote analog programming is user selectable 0-5V
or 0-10V.
Semiconductor Processing and Burn-in
Safe-Start may be ENABLED to re-start at Output
OFF to protect load.
Wide range input (85-265Vac) with Active Power
Factor correction rides through input transients easily.
RF Amplifiers and Magnets
Robust design assures stable operation under a wide
variety of loads.
High linearity in voltage and current mode.
Component Test
High power density, zero stacking and single wire
parallel operation give maximum system flexibility.
Rear Panel Description
1. Remote/Local Output Voltage Sense Connections.
2. DIP Switches select 0-5V or 0-10V Programming and other functions.
3. DB25 (Female) connector allows (Non-isolated) Analog Program and Monitor and other functions.
4. RS-485 OUT to other Genesys™ Power Supplies.
5. RS-232/RS-485 IN Remote Serial Programming.
6. Wide-Range Input 85-265VAC continuous, 47/63Hz with Active Power Factor Correction (0.99 typical)
AC Input Connector: IEC320.
7. Exit air assures reliable operation when zero stacked.
8. Output Connections: Rugged busbars for 6V up to 60V Output; Connector for Outputs >60V.
9. Optional Interface Position for IEEE 488.2 SCPI (shown) or Isolated Analog Interface or LAN Interface.
GENH | GENESYS™ | 3