1mm Pitch FPC/FFC Connector
FH 21 Series
ꢀFeatures
1. LIF (Low Insertion Force) Mechanism
LIF mechanism secures mounting serviceability.
2. Kink Mechanism
DIP post is treated with kinks, and prevent connector
floating in the soldering process.
3. Contact Structure on Both Sides
The contact structure on both sides does restrict
directionality of FPC and FFC conductors.
ꢀApplications
HDD, facsimiles, printers, and crystal liquie modules, etc.
ꢀProduct Specifications
+
+
Rated Current: 0.5A
Operating Temperature Range: -30 ~ 70ç (Note 1) Storage Temperature Range: -10 ~ 50ç (Note 2)
Rating
Rated Voltage: 50V AC Operating Humidity Range: Relative humidity 90% max. Storage Humidity Range: Relative Humidity: 90% max.
(Not dewed)
(Not dewed)
Applicable FPC
Item
t=0.3 0.05 Solder plating
Specification
Condition
1. Insulation Resistance 500Mø min.
Measured at 100V DC
150V AC for 1 minute
2. Withstand voltage
Neither short nor breakdown should occur
40mø
3. Contact Resistance
Measured at 100mA
10 cycles
*FPC conductor resistance included
Contact resistance: 40mø max.
Mechanical
4.
Operation
No part should be damaged, cracked, or loosened
Electrical discontinuity, 1µS max.
Contact resistance: 40mø
Frequency 10~55Hz and single amplitude 0.75mm in
3 directions for 2 hours, respectively.
5. Vibration
6. Shock
No part should be damaged, cracked, or loosened
Electrical discontinuity, 1µS max.
Contact resistance: 40mø max.
Acceleration: 490m/s, duration: 11ms, sine half-wave
in 3 directions for 3 cycles, respectively
No part should be damaged, cracked, or loosened
Contact resistance: 40mø max.
7. Moisture Resistance
7. in Steady State
Exposed to temperature 60ç and humidity 90~95%
Insulation resistance: 50M
ø max.
for 96 hours
No part should be damaged, cracked, or loosened
Note 1. Temperature rise included when energized
Note 2. This storage indicates a long-term storage state for the unused product before the board mounted.
Note 2. The operating temperature and humidity ranges are applied to the non-energized state after the connector has been
installed in the board.
Note 3. The above standards represent this series. The individual formal agreement should be based on the "Specification".
D15