EL7585A
®
Data Sheet
September 21, 2005
FN7523.2
TFT-LCD Power Supply
The EL7585A represents a multiple output regulators for use
in all large panel, TFT-LCD applications. It features a single
boost converter with integrated 3.5A FET, two positive LDOs
Features
• 3.5A current limit FET options
• 3V to 5V input
• Up to 20V boost out
• 1% regulation on all outputs
for V
for V
and V
OFF
generation, and a single negative LDO
ON
LOGIC
generation. The boost converter can be
programmed to operate in either P-mode or PI-mode for
improved load regulation.
• V
-V
-V
BOOST OFF ON
or
OFF BOOST ON
V
-V -V
sequence control
The EL7585A also integrates fault protection for all four
channels. Once a fault is detected, the device is latched off
until the input supply or EN is cycled. This device also
- V
is on from start-up for EL7585A
LOGIC
• Programmable sequence delay
• Fully fault protected
features an integrated start-up sequence for V
V
,
BOOST, OFF
sequencing. The
then V
or for V
, V
, and V
ON
OFF BOOST
ON
• Thermal shutdown
latter requires a single external transistor. The timing of the
start-up sequence is set using an external capacitor. The
• Internal soft-start
V
output is constantly enabled, but does shut down
LOGIC
• 20 Ld QFN packages
when a fault condition is detected.
• Pb-free plus anneal available (RoHS compliant)
The EL7585A is specified for operation over the -40°C to
+85°C temperature range.
Applications
• LCD monitors (15”+)
Pinout
EL7585A
(20 LD QFN)
TOP VIEW
• LCD-TV (up to 40”+)
• Notebook displays (up to 16”)
• Industrial/medical LCD displays
Ordering Information
PART
TAPE&
PKG.
CDLY
DELB
LX1
1
2
3
4
5
15 CINT
14 VREF
13 PGND
12 PGND
11 FBN
PART NUMBER MARKING
PACKAGE
REEL DWG. #
EL7585AILZ
(Note)
EL7585AIL Z 20 Ld 4x4 QFN
(Pb-free)
-
MDP0046
MDP0046
MDP0046
THERMAL
PAD
EL7585AILZ-T7 EL7585AIL Z 20 Ld 4x4 QFN
(Note) (Pb-free)
7”
LX2
DRVP
EL7585AILZ-T13 EL7585AIL Z 20 Ld 4x4 QFN
(Note) (Pb-free)
13”
NOTE: Intersil Pb-free plus anneal products employ special Pb-free
material sets; molding compounds/die attach materials and 100%
matte tin plate termination finish, which are RoHS compliant and
compatible with both SnPb and Pb-free soldering operations. Intersil
Pb-free products are MSL classified at Pb-free peak reflow
temperatures that meet or exceed the Pb-free requirements of
IPC/JEDEC J STD-020.
CAUTION: These devices are sensitive to electrostatic discharge; follow proper IC Handling Procedures.
1-888-INTERSIL or 1-888-468-3774 | Intersil (and design) is a registered trademark of Intersil Americas Inc.
Copyright Intersil Americas Inc. 2005. All Rights Reserved
1
All other trademarks mentioned are the property of their respective owners.