5秒后页面跳转
EL1526IL PDF预览

EL1526IL

更新时间: 2024-01-19 17:05:24
品牌 Logo 应用领域
英特矽尔 - INTERSIL 驱动器
页数 文件大小 规格书
2页 105K
描述
Dual Channel Differential DSL Line Driver for Centillium Maximus CO Chipsets

EL1526IL 技术参数

是否Rohs认证: 不符合生命周期:Obsolete
Reach Compliance Code:not_compliant风险等级:5.9

EL1526IL 数据手册

 浏览型号EL1526IL的Datasheet PDF文件第2页 
EL1526  
®
Data Sheet  
May 13, 2004  
FN7405  
Dual Channel Differential DSL Line Driver  
for Centillium Maximus CO Chipsets  
Features  
• 450mA output drive capability  
The EL1526 is to be used with  
Centillium's Maximus CO chipset for  
• 44.1V differential output drive into 100  
P-P  
• -85dBc THD @ 1MHz 2V  
very high performance ADSL  
P-P  
applications. The line driver supports use of ADSL  
downstream spectrum up to 3.75MHz, beyond traditional  
1.1MHz range. For the extended spectrum, payload rates up  
to 50Mbps is achievable in conjunction of High-Bit-Loading  
(HBL) feature of Maximus CO chipset. This feature allows  
DMT tones to carry higher than 15 bits per tone, resulting in  
higher performance ADSL services.  
• High slew rate of 500V/µs  
• Bandwidth - 46MHz  
• Current control pins  
• Channel separation  
- 80dB @ 500kHz  
- 75dB @ 1MHz  
The EL1526 is an integral part of the signal chain for HBL.  
The driver has been optimized for flat gain response and  
reduced harmonic distortion and noise in the bands of  
interest to improve the overall signal to noise in the system.  
A unique internal compensation circuit eliminates the need  
for external common mode snubber filters in active  
termination applications.  
Applications  
• ADSL line drivers for Centillium Maximus CO chipsets  
Ordering Information  
PART  
TAPE &  
REEL  
NUMBER  
PACKAGE  
24-Pin QFN  
24-Pin QFN  
24-Pin QFN  
PKG. DWG. #  
MDP0046  
MDP0046  
MDP0046  
These drivers achieve a total harmonic distortion (THD)  
measurement of typically -64dB @ 2.2MHz, while  
consuming typically 5mA per DSL channel of total supply  
current. This supply current can be set using a resistor on  
EL1526IL  
-
EL1526IL-T7  
EL1526IL-T13  
7”  
13”  
the I  
pin. Two other pins (C & C ) can also be used to  
ADJ  
0 1  
adjust supply current to one of four pre-set modes (full-I ,  
S
3/4-I , 1/2-I , and full power-down). The EL1526 operates  
on ±5V to ±12V supplies and retains its bandwidth and  
linearity over the complete supply range.  
S
S
Get FULL DATASHEET  
The device is supplied in the small footprint (4x5mm) 24-pin  
QFN package and is specified for operation over the full  
-40°C to +85°C temperature range.  
CAUTION: These devices are sensitive to electrostatic discharge; follow proper IC Handling Procedures.  
1
1-888-INTERSIL or 321-724-7143 | Intersil (and design) is a registered trademark of Intersil Americas Inc.  
Copyright © Intersil Americas Inc. 2004. All Rights Reserved. Elantec is a registered trademark of Elantec Semiconductor, Inc.  
All other trademarks mentioned are the property of their respective owners.  

与EL1526IL相关器件

型号 品牌 获取价格 描述 数据表
EL1526IL-T13 INTERSIL

获取价格

Dual Channel Differential DSL Line Driver for Centillium Maximus CO Chipsets
EL1526IL-T7 INTERSIL

获取价格

Dual Channel Differential DSL Line Driver for Centillium Maximus CO Chipsets
EL1526ILZ INTERSIL

获取价格

Dual Channel Differential DSL Line Driver for Centillium Maximus CO Chipsets
EL1526ILZ-T13 INTERSIL

获取价格

Dual Channel Differential DSL Line Driver for Centillium Maximus CO Chipsets
EL1526ILZ-T7 INTERSIL

获取价格

Dual Channel Differential DSL Line Driver for Centillium Maximus CO Chipsets
EL1526IRE-T13 RENESAS

获取价格

EL1526IRE-T13
EL1527 INTERSIL

获取价格

Dual Channel Medium Power Differential Line Driver
EL1527CRE INTERSIL

获取价格

Dual Channel Medium Power Differential Line Driver
EL1527CRE-T13 INTERSIL

获取价格

Dual Channel Medium Power Differential Line Driver
EL1527CRE-T7 INTERSIL

获取价格

Dual Channel Medium Power Differential Line Driver