Aluminum Electrolytic Capacitors/ HC
Snap-in Type
Series:
Type:
HC
TS
■ Features
Endurance : 105 °C 2000 h
30 % smaller than series TS-HB
RoHS directive compliant
●
●
●
■ Specifications
Category Temp. Range
Rated W.V. Range
Nominal Cap. Range
Capacitance Tolerance
–40 °C to +105 °C
10 V.DC to 100 V.DC 160 V.DC to 250 V.DC
820 µF to 100000 µF
–25 °C to +105 °C
315 V.DC to 450 V.DC
39 µF to 1000 µF
150 µF to 3300 µF
20 % (120 Hz/+20 °C)
3
CV (µA) max. After 5 minutes application of rated working voltage at +20 °C.
C : Capacitance (µF) V: W.V. (V.DC)
ǰ
DC Leakage Current
tan
Please see the attached standard products list
δ
Frequency (Hz)
10 V.DC to 100 V.DC /C.F.
160 V.DC to 450 V.DC /C.F.
50
0.93
0.75
60
0.95
0.80
100
0.99
0.95
120
1.00
1.00
500
1.05
1.20
1 k
1.08
1.25
10 k to
1.15
1.40
Frequency Correction
Factor for Ripple Current
After 2000 hours application of DC voltage with specified ripple current ( rated DC working voltage)
<
at +105 °C 2 °C, the capacitors shall meet the following limits.
Endurance
Shelf Life
Capacitance change
20 % of initial measured value
200 % of initial specified value
initial specified value
<
<
<
tan
δ
DC leakage current
After storage for 1000 hours at +105 °C 2 °C within no voltage applied and then being stabilized
at +20 °C, capacitors shall meet the limits specified in Endurance. (With voltage treatment)
■ Dimensions in mm (not to scale)
(mm)
2-φ2.0 0.1
Sleeve
Polarity bar
Vent
L+2.0 max.
(φD)
4.0 0.5
Rated voltage etc. indicate to sleeve.
Recommended PWB piercing plan
+0.2
2.0 max.
Terminal
(t=0.8)
0.8
–0.1
Top of spin
1.5 0.2
Standard terminal type does not require
terminal trimming peocess.
Design and specifications are each subject to change without notice. Ask factory for the current technical specifications before purchase and/or use.
Should a safety concern arise regarding this product, please be sure to contact us immediately.
Jul. 2008