®
Sure Cross Performance Node
Datasheet
®
The Sure Cross wireless system is a radio frequency network with integrated I/O that operates in most environments to eliminate
the need for wiring runs. The Performance Series P6L Node is low-cost, battery-powered device that can convert Banner 1-wire
serial sensor device into a wireless input. All configuration is done through internal DIP switches or the DX80 User Configuration
Tool.
Benefits
•
Deliver factory automation or IIoT solutions by connecting any Banner 1-wire serial sensor for applications such as:
◦
◦
◦
Ultrasonic distance measurement for tank level monitoring, distance sensing, etc
Vibration and temperature for predictive maintenance motor health monitoring
Temperature and humidity for energy management, process monitoring, etc
•
•
•
Longer Battery Life—Large D cell battery gives extended battery life vs. Q45 1-wire serial devices
Compact Design—Internal antenna for smaller footprint
Eliminate control wires—The Sure Cross wireless system is a radio frequency network with integrated I/O that removes the
need for power and control wires.
•
•
Reduce complexity—Machine or process reconfiguration made easier; great for retrofit applications
Deploy easily—Simplified installation on existing equipment enables deployment in remote and hard-to-access locations
where implementing a wired solution would be difficult, impractical, or not cost-effective
•
Selectable transmit power levels of 250 mW or 1 Watt for 900 MHz models and 65 mW for 2.4
GHz models
•
•
DIP switches for user configuration
Frequency Hopping Spread Spectrum (FHSS) technology and Time Division Multiple Access
(TDMA) control architecture ensure reliable data delivery within the unlicensed Industrial,
Scientific, and Medical (ISM) band
•
•
Transceivers provide bidirectional communication between the Gateway and Node, including
fully acknowledged data transmission
Diagnostics allow user-defined output settings in the unlikely event of lost RF signal
For additional information, updated documentation, and a list of accessories, refer to Banner
Engineering's website, www.bannerengineering.com/wireless.
WARNING: Not To Be Used for Personnel Protection
Never use this device as a sensing device for personnel protection. Doing so could lead to serious injury or
death. This device does not include the self-checking redundant circuitry necessary to allow its use in
personnel safety applications. A sensor failure or malfunction can cause either an energized or de-energized
sensor output condition.
CAUTION: Never Operate 1 Watt Radios Without Antennas
®
To avoid damaging the radio circuitry, never power up Sure Cross Performance or Sure Cross MultiHop (1
Watt) radios without an antenna.
CAUTION: Electrostatic Discharge (ESD)
ESD Sensitive Device. This product uses semiconductors that can be damaged by electrostatic discharge
(ESD). When performing maintenance, care must be taken so the device is not damaged. Disconnect power
from the device when accessing the internal DIP switches. Proper handling procedures include wearing anti-
static wrist straps. Damage from inappropriate handling is not covered by warranty.
Models
Models
Frequency
Power
I/O
DX80N9X1W-P6L
DX80N2X1W-P6L
900 MHz ISM Band
2.4 GHz ISM Band
Inputs: 1-Wire serial interface for one serial sensing
device
Integrated battery
Original Document
204221 Rev. A
12 February 2018
204221