DS4830
Optical Microcontroller
General Description
Features
The DS4830 provides a complete optical control, calibra-
tion, and monitor solution based on a low-power, 16-bit,
microcontroller core, providing program and RAM data
memory. I/O resources include a fast/accurate analog-to-
digital converter (ADC), fast comparators with an internal
comparison digital-to-analog converter (DAC), 12-bit
DACs, 12-bit PWMs, internal and external temperature
S 16-Bit Low-Power Microcontroller
S 36 kWords Total Program Memory
32 kWords Flash Program Memory
4 kWords ROM Program Memory
S 1 kWords Data RAM
S 8 DAC Channels
2
12-Bit Buffered Voltage DACs
Internal or External Reference
sensors, fast sample/hold, I C slave host interface, and
a multiprotocol serial master/slave interface.
S 10 PWM Channels
Direct connection of diode-connected transistors, used
as remote temperature sensors, is supported as well as
expansion to additional external digital temperature sen-
Boost/Buck DC-DC Control with Support for
7-Bit to 12-Bit Resolution and 1MHz Switching
Frequency
2
sor ICs using the on-chip master I C interface. An inde-
2
Supports 4-Channel TECC H-Bridge Control
pendent slave I C interface facilitates communication to
a host microprocessor in addition to password-protected
in-system reprogramming of the on-chip flash.
S 8-Bit Fast Comparator with 16-Input Mux
1.6µs per Comparison
Firmware development is supported by third-party highly
versatile C-compilers and development software that
programs flash and performs in-circuit debug through
the integrated JTAG interface and associated hardware.
S 13-Bit A/D Converter with 26-Input Mux (27ksps)
S Temperature Measurement Analog Front-End
Internal Temperature Sensor, 3NC
0.0625NC Resolution
Supports Two External Temperature Sensors
Differential Rail-Rail Inputs
Applications
PON Diplexers and Triplexers: GPON, 10GEPON,
XPON OLT, ONU
S 31 GPIO Pins
S Maskable Interrupt Sources
Optical Transceivers: XFP, SFP, SFP+, QSFP,
40G, 100G
S Internal 20MHz Oscillator, CPU Core Frequency 10MHz
4% Accurate from 0NC to +50NC
S Up to 133MHz External Clock for PWM and Timers
S Slave Communication Interface: SPI or 400kHz
Ordering Information appears at end of data sheet.
2
I C-Compatible 2-Wire
2
S Master Communication Interface: SPI, 400kHz I C-
Compatible, or Maxim 3-Wire Laser Driver
Typical Application Circuit appears at end of data sheet.
2
S I C and JTAG Bootloader
S Two 16-Bit Timers
S 2.97V to 3.63V Operating Voltage Range
S Brownout Monitor
S JTAG Port with In-System Debug and Programming
S Low Power Consumption (16mA) with All Analog
Active
For related parts and recommended products to use with this part, refer to: www.maximintegrated.com/DS4830.related
Note: Some revisions of this device may incorporate deviations from published specifications known as errata. Multiple revisions of any device may
be simultaneously available through various sales channels. For information about device errata, go to: www.maximintegrated.com/errata.
For pricing, delivery, and ordering information, please contact Maxim Direct at
1-888-629-4642, or visit Maxim Integrated’s website at www.maximintegrated.com.
19-5934; Rev 2; 6/13