5秒后页面跳转
DS3896_09 PDF预览

DS3896_09

更新时间: 2024-11-22 06:54:43
品牌 Logo 应用领域
美国国家半导体 - NSC /
页数 文件大小 规格书
10页 338K
描述
BTL Trapezoidal™ Transceivers

DS3896_09 数据手册

 浏览型号DS3896_09的Datasheet PDF文件第2页浏览型号DS3896_09的Datasheet PDF文件第3页浏览型号DS3896_09的Datasheet PDF文件第4页浏览型号DS3896_09的Datasheet PDF文件第5页浏览型号DS3896_09的Datasheet PDF文件第6页浏览型号DS3896_09的Datasheet PDF文件第7页 
OBSOLETE  
January 6, 1996  
DS3896/DS3897  
BTL TrapezoidalTransceivers  
equivalent DC load of 18.5Ω (or greater) in the above config-  
uration.  
General Description  
These advanced transceivers are specifically designed to  
overcome problems associated with driving a densely popu-  
lated backplane, and thus provide significant improvement in  
both speed and data integrity. Their low output capacitance,  
low output signal swing and noise immunity features make  
them ideal for driving low impedance buses with minimum  
power consumption.  
These signalling requirements, including a 1 volt signal swing,  
low output capacitance and precise receiver thresholds are  
referred to as Bus Transceiver Logic (BTL).  
Features  
8 bit DS3896 transceiver provides high package density  
4 bit DS3897 transceiver provides separate driver input  
and receiver outpins  
The DS3896 is an octal high speed schottky bus transceiver  
with common control signals, whereas the DS3897 is a quad  
device with independent driver input and receiver output pins.  
The DS3897 has a separate driver disable for each driver and  
is, therefore, suitable for arbitration lines. The separate driver  
disable pins (En) feature internal pull ups and may be left open  
if not required. On the other hand, the DS3896 provides high  
package density for data/address lines.  
BTL compatibl
Less than 5 pF oapaance for minimal bus loading  
1 Volt bus gnal swiuces power consumption  
Trapezdriver waveforms (tr, tf ≃ 6 ns typical) reduce  
noise upliadjacent lines  
Teperature insitive receiver thresholds track the bus  
lc high level to maximize noise immunity in both high  
d lostates  
The open collector drivers generate precise trapezoidal  
waveforms, which are relatively independent of capacitive  
loading conditions on the outputs. This significantly reduces  
noise coupling to adjacent lines. In addition, the receivers use  
a low pass filter in conjunction with a high speed comparator,  
to further enhance the noise immunity and provide equal re
jection to both negative and positive going noise pulses on  
the bus.  
Gtee.C. specifications on noise immunity and  
propadelay over the specified temperature and  
supply votage range  
Opeollector driver output allows wire-or connection  
nced low power schottky technology  
To minimize bus loading, these devices also feature
tky diode in series with the open collector output tha
the driver output capacitance in the disabled state. T
low voltage is typically “1V” and the output high lev
tended to be 2V. This is achieved by terminatthe bus
a pull up resistor to 2V at both ends. The dee can ve an  
Glitch free power up/down protection on driver and  
receiver outputs  
TTL compatible driver and control inputs and receiver  
outputs  
Trapezoidal™ is a trademark of National Semiconductor Corporation.  
© 2009 National Semiconductor Corporation  
8510  
www.national.com  
8510 Version 6 Revision 2 Print Date/Time: 2009/07/20 16:46:54  

与DS3896_09相关器件

型号 品牌 获取价格 描述 数据表
DS3896J ETC

获取价格

Single 8-Bit Inverting Bus Transceiver
DS3896J/A+ ETC

获取价格

Single 8-Bit Inverting Bus Transceiver
DS3896M NSC

获取价格

BTL Trapezoidal⑩ Transceivers
DS3896MX NSC

获取价格

IC OCTAL LINE TRANSCEIVER, PDSO20, 0.300 INCH, SOP-20, Line Driver or Receiver
DS3896N NSC

获取价格

BTL Trapezoidal⑩ Transceivers
DS3896N/A+ ETC

获取价格

Single 8-Bit Inverting Bus Transceiver
DS3896N/B+ ETC

获取价格

Single 8-Bit Inverting Bus Transceiver
DS3897 NSC

获取价格

BTL Trapezoidal⑩ Transceivers
DS3897J ETC

获取价格

4-Bit Bus Transceiver
DS3897J/A+ ETC

获取价格

4-Bit Bus Transceiver