5秒后页面跳转
DS1667-010 PDF预览

DS1667-010

更新时间: 2024-11-29 22:19:47
品牌 Logo 应用领域
达拉斯 - DALLAS 运算放大器
页数 文件大小 规格书
10页 364K
描述
Digital Resistor with OP AMP

DS1667-010 技术参数

生命周期:Obsolete包装说明:0.300 INCH, DIP-20
Reach Compliance Code:unknown风险等级:5.8
模拟集成电路 - 其他类型:ANALOG CIRCUITJESD-30 代码:R-PDIP-T20
功能数量:1端子数量:20
最高工作温度:70 °C最低工作温度:
封装主体材料:PLASTIC/EPOXY封装形状:RECTANGULAR
封装形式:IN-LINE认证状态:Not Qualified
最大供电电压 (Vsup):5.5 V最小供电电压 (Vsup):4.5 V
标称供电电压 (Vsup):5 V表面贴装:NO
技术:CMOS温度等级:COMMERCIAL
端子形式:THROUGH-HOLE端子位置:DUAL
Base Number Matches:1

DS1667-010 数据手册

 浏览型号DS1667-010的Datasheet PDF文件第2页浏览型号DS1667-010的Datasheet PDF文件第3页浏览型号DS1667-010的Datasheet PDF文件第4页浏览型号DS1667-010的Datasheet PDF文件第5页浏览型号DS1667-010的Datasheet PDF文件第6页浏览型号DS1667-010的Datasheet PDF文件第7页 
DS1667  
Digital Resistor with OP AMP  
www.dalsemi.com  
FEATURES  
PIN ASSIGNMENT  
Two digitally controlled 256-position  
potentiometers  
NINV0  
INV0  
VB  
1
2
20  
19  
18  
17  
16  
15  
14  
13  
12  
11  
VCC  
OUT0  
SOUT  
W0  
Serial port provides means for setting and  
reading both potentiometers  
3
W1  
4
Resistors can be connected in series to  
provide additional resolution  
H1  
5
H0  
L1  
6
L0  
RST  
CLK  
OUT1  
GND  
7
COUT  
DQ  
Default wiper position on power up is 50%  
Resistive elements are temperature-  
compensated to +20% end to end  
Two high-gain, wide bandwidth operational  
amplifiers  
8
9
INVI  
NINVI  
10  
20-Pin DIP (300-mil) and 20-Pin SOIC  
See Mech. Drawings Section  
Low power CMOS design  
Applications include analog-to-digital and  
digital-to-analog converters, variable  
oscillators, and variable gain amplifiers  
20-pin DIP package or optional 20-pin SOIC  
surface mount package  
Operating temperature range  
- Commercial: 0°C to 70°C  
Resistance values:  
PIN DESCRIPTION  
VCC  
- +5-Volt Supply  
GND  
L0, L1  
H0, H1  
W0, W1  
VB  
- Ground  
- Low End of Resistor  
- High End of Resistor  
- Wiper End of Resistor  
- Substrate Bias and OP  
AMP Negative Supply  
- Wiper for Stacked  
Configuration  
SOUT  
RESOLUTION -3 dB POINT  
DS1667-10: 10k 39 ohms  
DS1667-50: 50k 195 ohms  
DS1667-100: 100k 390 ohms 100 kHz  
1.1 MHz  
200 kHz  
RST  
DQ  
CLK  
COUT  
- Serial Port Reset Input  
- Serial Port Input/Output  
- Serial Port Clock Input  
- Cascade Serial Port  
Output  
NINV0, NINVI  
- Noninverting OP AMP  
Input  
INV0, INVI  
OUT0, OUT1  
- Inverting OP AMP Input  
- OP AMP Outputs  
DESCRIPTION  
The DS1667 is a dual-solid state potentiometer that is adjustable by digitally selected resistive elements.  
Each potentiometer is composed of 256 resistive elements. Between each resistive section of each  
potentiometer are tap points accessible to the wiper. The position of the wiper on the resistive array is set  
by an 8-bit register that controls which tap point is connected to the wiper output. Each 8-bit register can  
be read or written by sending or receiving data bits over a 3-wire serial port. In addition, the resistors can  
be stacked such that a single potentiometer of 512 sections results. When two separate potentiometers are  
used, the resolution of the DS1667 is equal to the resistance value divided by 256. When the  
potentiometers are stacked end to end, the resistance value is doubled while the resolution remains the  
1 of 10  
032000  

与DS1667-010相关器件

型号 品牌 获取价格 描述 数据表
DS1667-050 DALLAS

获取价格

Analog Circuit, 1 Func, CMOS, PDIP20, 0.300 INCH, DIP-20
DS1667-10 DALLAS

获取价格

Digital Resistor with OP AMP
DS1667-100 DALLAS

获取价格

Digital Resistor with OP AMP
DS1667-50 DALLAS

获取价格

Digital Resistor with OP AMP
DS1667N-10 ETC

获取价格

Voltage-Feedback Operational Amplifier
DS1667N-100 ETC

获取价格

Voltage-Feedback Operational Amplifier
DS1667N-50 ETC

获取价格

Voltage-Feedback Operational Amplifier
DS1667S-010 DALLAS

获取价格

Analog Circuit, 1 Func, CMOS, PDSO20, SOIC-20
DS1667S-10 ETC

获取价格

Voltage-Feedback Operational Amplifier
DS1667S-100 DALLAS

获取价格

Analog Circuit, 1 Func, CMOS, PDSO20, SOIC-20