DM562AP
V.90 Integrated Data/ Fax/Voice/Speakerphone
Modem Device Single Chip with Memory Built in
General Description
The DM562AP integrated modem is a two-chipset
design that provides a complete solution for state-
of-the-art, voice-band Plain Old Telephone
Switching (POTS) communication. The modem
provides for Data (up to 56,000bps), Fax (up to
ban0bps), Voice and Full Duplex Speaker-phone
functions to comply with various international
standards.
The DM562AP modem reference design is pre-
approved for FCC part 68 and provides minimum
design cycle time, with minimum cost to insure the
maximum amount of success.
The simplified modem system, shown in figure
below, illustrates the basic interconnection between
the MCU, DSP, AFE and other basic components of
a modem. The individual elements of the DM562AP
are:
The design of the DM562AP is optimized for
desktop personal computer applications, embedded
microprocessor applications and Multi-Function
Peripheral (MFP) FAX application. It provides a low
cost, highly reliable, maximum integration, with the
minimum amount of support required. The
•
•
DM6580 Analog Front End (AFE). 48-pin LQFP
package.
DM6588A ITU-T V.90 integrated Processors
with 32K bytes SRAM built in 128-pin QFP
package
DM562AP modem can operate over a dial-up
network (PSTN) or 2 wire leased lines.
The modem integrates auto dial and answer
capabilities, asynchronous data transmissions,
serial and parallel interfaces, various tone detection
schemes and data test modes.
Block Diagram
Ring
LED
30.24MHz
Detector
Optional
SCLK
DIT
DOT
TFS
DIR
DOR
RFS
29.4912MHz
DM6580
RxIN
Micro
TX
DSP
Controller
Unit
TxA1
DAA
Line
TxA2
Analog
DM6588A
Front End
PCI
Bus
PnP
32KB
SRAM
Speaker
SPKR
TXSCLK*2
RXSCLK
CLKIN
TXDCLK
RXDCLK
RX
DSP
ISA
Bus
Driver
UART
V.24
Microphone
Driver
Interface
2M
Flash
V.24
Interface
Preliminary
1
Version: DM562AP-DS-P02
March 05, 2004