DAC-011A
PARALLEL DIGITAL TO RGB AND YPBPR MODULE
·
·
·
Small compact design for pcb mounting
bit component outputs
Inputs with single pin control
·
·
·
Auto & forced 625/525 operation
Simultaneous RGB or YPbPr
Full video bandwidth filtered outputs
This interface card accepts CCIR656 parallel data and provides simultaneous component RGB and YPbPr analogue
outputs, together with separate mixed sync’s. The card accepts two inputs which can be selected via a single pin
control. With other features such as the addition of mixed sync’s to analogue outputs and automatic or forced 625/525
operation it is anticipated that this versatile module will provide more solutions than just interfacing to most broadcast
monitors..
Input Requirements
Input
2 x digital inputs at TTL or CMOS levels.
(CCIR656/SMPTE RP-125 coded)
625/525 (Auto detection or forced operation)
12nS min (data to clk rising edge)
Line standard
Set up time
Hold time
2nS min (clk rising edge to data)
Component Output Characteristics
Output format
Output levels
Resolution
Simultaneous YPbPr and RGB
700 mV ±1%
10 bit
Freq. Response
< 0.2 dB to 5.5 MHz (RGB or Y),
< 0.2 to 2.2 MHz (PbPr)
1% typical
K-rating (2T)
Noise
>70 dB rms to 5.5 MHz
Sync Output Characteristics
Other parameters
Sync output amplitude
Sync amp. on RGB or Y
2V ±5% into 75 ohm
300 mV ±10mV into 75 ohm
Power
+5V ±0.25V (200mA max)
- 5V ±0.25V (80mA max)
00C to 400C
No
DR00173A
Operating Temp.
Aqueous Washable
Package
DAC-011A Control Information
+5V or Open Circuit
0V
Control 0
Control 1
Control 2
Control 3
See table below
See table below
SYNC’s on RGB and Y
Input 1 selected
See table below
See table below
No SYNC’s on RGB or Y
Input 2 selected
DAC-011A Standards Selection
Control 0
0V
+5V or floating
+5V or floating
Control 1
+5V or floating
+5V or floating
0V
625
AUTO
525
© Faraday Technology. As part of continual product improvement the specifications, details and dimensions shown in this publication are subject to change without notice
FARA077d Page 1 of 2 Jan-00(B)