CM6503/4
8-PIN SINGLE PFC CONTROLLER WITH 50% PWM CLOCK SIGNAL
GENERAL DESCRIPTION
FEATURES
The 8 pin single PFC controller with 50% PWM clock ,
ꢀ
Enable lowest BOM for power supply with PFC
CM6503/4 is a space-saving controller for power factor ꢀ
corrected, switched mode power supplies that offers very
low start-up and operating currents. For the power supply ꢀ
less than 500Watt, its performance could be very close to ꢀ
CM6800 or ML4800 architecture. Its IAC has dual function. ꢀ
8 pin CM6503/4 does not require and bleed resistors. It use
IAC pin during the start up condition to start up CM6503/4. ꢀ
After CM6503/4 is on, IAC will switch itself back to the IAC
Patented slew rate enhanced voltage error amplifier with
advanced input current shaping technique
Universal Line Input Voltage
No bleed resistor required
CCM boost or DCM boost with leading edge modulation
PFC using Input Current Shaping Technique
Feedforward IAC pin to do the automatic slope
compensation
function.
ꢀ
PFCOVP, TriFault Detect, PFC VCCOVP, Precision -1V
PFC ILIMIT
Power Factor Correction (PFC) offers the use of smaller, ꢀ
lower cost bulk capacitors, reduces power line loading and
stress on the switching FETs, and results in a power supply ꢀ
fully compliant to IEC1000-3-2 specifications. The
CM6503/4 includes circuits for the implementation of a
leading edge, average current “boost” type PFC and a
trailing edge, PWM Clock signal which will not turn on until ꢀ
PFC boost output reaches steady state.
Low supply currents; start-up: 100uA typical, operating
current: 2mA typical.
Synchronized leading PFC and trailing edge modulation
PWM Clock for the down stream DC to DC stage to reduce
ripple current in the storage capacitor between the PFC and
PWM sections and to reduce switching noise in the system
VINOK Comparator to guarantee to enable PWM Clock
when PFC reach steady state
ꢀ
UVLO, VREFOK, and brownout protection
The CM6503’s PFC and PWM Clock operate at the same
frequency, 67kHz. The PFC frequency of the CM6504 is
automatically set at half that of the 134kHz PWM. This
higher frequency allows the user to design with smaller
PWM components while maintaining the optimum operating
frequency for the PFC. An PFC OVP comparator shuts
down the PFC section in the event of a sudden decrease in
load. The PFC section also includes peak current limiting
for enhanced system reliability.
24 Hours Technical Support---WebSIM
Champion provides customers an online circuit simulation tool
called WebSIM. You could simply logon our website at
www.champion-micro.com for details.
APPLICATIONS
PIN CONFIGURATION
DIP-08 (P08)
ꢀ
ꢀ
ꢀ
ꢀ
ꢀ
ꢀ
ꢀ
ꢀ
ꢀ
ꢀ
Desktop PC Power Supply
AC Adaptor
Top View
Internet Server Power Supply
IPC Power Supply
1
2
3
4
PFCOUT PWMCLK
8
7
6
5
UPS
Battery Charger
DC Motor Power Supply
Monitor Power Supply
Telecom System Power Supply
Distributed Power
VCC
IAC
VFB
GND
ISENSE
VEAO
2002/07/16 Preliminary Rev. 0.2
Champion Microelectronic Corporation
Page 1