Datasheet > C1608X7R1C473K

C1608X7R1C473K

更新时间： 2024-11-24 09:45:27

品牌	Logo	应用领域
美国国家半导体 - NSC		/
页数	文件大小	规格书
10页	1211K
描述
Evaluation Board provides the design engineer with a fully functional

阅读下载

中文翻译

获取价格

数据手册

如果您发现信息不准确，欢迎纠错

C1608X7R1C473K 数据手册

National Semiconductor

Application Note 2066

Eric Lee

LM25119 Evaluation Board

September 28, 2010

ed to the J6 (OUT2+) and J5 (OUT2-/GND). Be sure to

choose the correct connector and wire size when attaching

the source power supply and the load.

Introduction

The LM25119EVAL evaluation board provides the design en-

gineer with a fully functional dual output buck converter, em-

ploying the LM25119 Dual Emulated Current Mode Syn-

chronous Buck Controller. The evaluation board is designed

to provide both 3.3V and 1.8V outputs over an input range of

6.0V to 36V. Also the evaluation board can be easily config-

ured for a single 3.3V, 16A regulator.

SOURCE POWER

The power supply and cabling must present low impedance

to the evaluation board. Insufficient cabling or a high

impedance power supply will droop during power supply ap-

plication with the evaluation board inrush current. If large

enough, this droop will cause a chattering condition during

power up. During power down, insufficient cabling or a high

impedance power supply will overshoot. This overshoot will

cause a non-monotonic decay on the output.

Performance of the Evaluation

Board

•

Input Voltage Range: 6.0V to 36V

Output Voltage: 3.3V (CH1), 1.8V (CH2)

Output Current: 8A (CH1), 8A (CH2)

Nominal Switching Frequency: 230 KHz

Synchronous Buck Operation: Yes

Diode Emulation Mode: Yes

An additional external bulk input capacitor may be required

unless the output voltage droop/overshoot of the source pow-

er is less than 0.5V. In this board design, UVLO setting is

conservative while UVLO hysteresis setting is aggressive.

Minimum input voltage can goes down with an aggressive

design. Minimum operating input voltage depends on the out-

put voltage droop/overshoot of the source power supply and

the forced off-time of the LM25119. Refer to the LM25119

datasheet for complete design information.

Hiccup Mode Overload Protection: Yes

External VCC Sourcing: No

Powering and Loading

Consideration

When applying power to the LM25119 evaluation board, cer-

tain precautions need to be followed. A misconnection can

damage the assembly.

When using an electronic load, it is strongly recommended to

power up the evaluation board at light load and then slowly

increase the load. If it is desired to power up the evaluation

board at maximum load, resistor banks must be used. In gen-

eral, electronic loads are best suited for monitoring steady

state waveforms.

PROPER BOARD CONNECTION

AIR FLOW

The input connections are made to the J1 (VIN) and J2 (RTN/

GND) connectors. The CH1 load is connected to the J3

(OUT1+) and J4 (OUT1-/GND) and the CH2 load is connect-

Prolonged operation with high input voltage at full power will

cause the MOSFETs to overheat. A fan with a minimum of

200LFM should be always provided.

30126101

FIGURE 1. Typical Evaluation Setup

301261

www.national.com

12 3 4 5 6 7...10

中文翻译

下载PDF

与C1608X7R1C473K相关器件

型号	品牌	获取价格	描述	数据表
C1608X7R1C473KT	TDK	获取价格	Ceramic Capacitor, Multilayer, Ceramic, 16V, 10% +Tol, 10% -Tol, X7R, 15% TC, 0.047uF, Sur
C1608X7R1C473M	TDK	获取价格	CAP CER 0.047UF 16V X7R 0603
C1608X7R1C474K	TDK	获取价格	TDK MLCC PRODUCT LINE
C1608X7R1C474K080AC	TDK	获取价格	CAP CER 0.47UF 16V X7R 0603
C1608X7R1C474M	TDK	获取价格	Ceramic Capacitor, Multilayer, Ceramic, 16V, 20% -Tol, X7R, 15% TC, 0.47uF, Surface Mount,
C1608X7R1C474M080AC	TDK	获取价格	CAP CER 0.47UF 16V X7R 0603
C1608X7R1C563K	TDK	获取价格	CAP,CERAMIC,56NF,16VDC,10% -TOL,10% +TOL,-15,15% TC,0603 CASE
C1608X7R1C563KB	TDK	获取价格	Ceramic Capacitor, Multilayer, Ceramic, 16V, 10% +Tol, 10% -Tol, X7R, 15% TC, 0.056uF, Sur
C1608X7R1C683K	TDK	获取价格	CAP CER 0.068UF 16V X7R 0603
C1608X7R1C683KT	TDK	获取价格	Ceramic Capacitor, Multilayer, Ceramic, 16V, 10% +Tol, 10% -Tol, X7R, 15% TC, 0.068uF, Sur

与C1608X7R1C473K相关文章

解析光耦仿真器：升级光耦合器技术的必要性
2024-11-18

38
英伟达新一代Blackwell GPU过热问题致交付延迟
2024-11-18

30
国产厂商思特威CMOS图像传感器芯片单月出货超1亿颗，技术创新引领行业发展
2024-11-14

58
台积电5nm和3nm产能利用率达100%，半导体行业景气度持续攀升
2024-11-14

54

产品中心

服务支持

精选活动

关于我们

帮助中心

C1608X7R1C473K

C1608X7R1C473K 数据手册

与C1608X7R1C473K相关器件

与C1608X7R1C473K相关文章

您还可以找

产品中心

服务支持

精选活动

关于我们

帮助中心

C1608X7R1C473K

C1608X7R1C473K 数据手册

与C1608X7R1C473K相关器件

与C1608X7R1C473K相关文章

您还可以找

您在本页遇到什么问题？