Datasheet > C1210C226K8RAC

C1210C226K8RAC

更新时间： 2024-11-23 09:40:51

品牌	Logo	应用领域
美国国家半导体 - NSC		电容器
页数	文件大小	规格书
10页	1211K
描述
Evaluation Board provides the design engineer with a fully functional

阅读下载

中文翻译

获取价格

数据手册

如果您发现信息不准确，欢迎纠错

C1210C226K8RAC 数据手册

National Semiconductor

Application Note 2066

Eric Lee

LM25119 Evaluation Board

September 28, 2010

ed to the J6 (OUT2+) and J5 (OUT2-/GND). Be sure to

choose the correct connector and wire size when attaching

the source power supply and the load.

Introduction

The LM25119EVAL evaluation board provides the design en-

gineer with a fully functional dual output buck converter, em-

ploying the LM25119 Dual Emulated Current Mode Syn-

chronous Buck Controller. The evaluation board is designed

to provide both 3.3V and 1.8V outputs over an input range of

6.0V to 36V. Also the evaluation board can be easily config-

ured for a single 3.3V, 16A regulator.

SOURCE POWER

The power supply and cabling must present low impedance

to the evaluation board. Insufficient cabling or a high

impedance power supply will droop during power supply ap-

plication with the evaluation board inrush current. If large

enough, this droop will cause a chattering condition during

power up. During power down, insufficient cabling or a high

impedance power supply will overshoot. This overshoot will

cause a non-monotonic decay on the output.

Performance of the Evaluation

Board

•

Input Voltage Range: 6.0V to 36V

Output Voltage: 3.3V (CH1), 1.8V (CH2)

Output Current: 8A (CH1), 8A (CH2)

Nominal Switching Frequency: 230 KHz

Synchronous Buck Operation: Yes

Diode Emulation Mode: Yes

An additional external bulk input capacitor may be required

unless the output voltage droop/overshoot of the source pow-

er is less than 0.5V. In this board design, UVLO setting is

conservative while UVLO hysteresis setting is aggressive.

Minimum input voltage can goes down with an aggressive

design. Minimum operating input voltage depends on the out-

put voltage droop/overshoot of the source power supply and

the forced off-time of the LM25119. Refer to the LM25119

datasheet for complete design information.

Hiccup Mode Overload Protection: Yes

External VCC Sourcing: No

Powering and Loading

Consideration

When applying power to the LM25119 evaluation board, cer-

tain precautions need to be followed. A misconnection can

damage the assembly.

When using an electronic load, it is strongly recommended to

power up the evaluation board at light load and then slowly

increase the load. If it is desired to power up the evaluation

board at maximum load, resistor banks must be used. In gen-

eral, electronic loads are best suited for monitoring steady

state waveforms.

PROPER BOARD CONNECTION

AIR FLOW

The input connections are made to the J1 (VIN) and J2 (RTN/

GND) connectors. The CH1 load is connected to the J3

(OUT1+) and J4 (OUT1-/GND) and the CH2 load is connect-

Prolonged operation with high input voltage at full power will

cause the MOSFETs to overheat. A fan with a minimum of

200LFM should be always provided.

30126101

FIGURE 1. Typical Evaluation Setup

301261

www.national.com

12 3 4 5 6 7...10

中文翻译

下载PDF

与C1210C226K8RAC相关器件

型号	品牌	获取价格	描述	数据表
C1210C226K8RACAUTO	KEMET	获取价格	Capacitor, Ceramic, Chip, General Purpose, 22
C1210C226K8RACAUTO7210	KEMET	获取价格	Capacitor, Ceramic, Chip, General Purpose, 22
C1210C226K8RACTM	KEMET	获取价格	Ceramic Capacitor, Multilayer, Ceramic, 10V, 10% +Tol, 10% -Tol, X7R, 15% TC, 22uF, Surfac
C1210C226K8RACTU	KEMET	获取价格	Capacitor, Ceramic, Chip, General Purpose, 22
C1210C226K8RALTU	KEMET	获取价格	Surface Mount Multilayer Ceramic Chip Capacitors (SMD MLCCs)
C1210C226K9PACTU	KEMET	获取价格	Ceramic, Commercial-(CxxxxC), 22 uF, 10%, 6.3 V, 1210, X5R, SMD, MLCC, Temperature Stable,
C1210C226K9RALTU	KEMET	获取价格	Surface Mount Multilayer Ceramic Chip Capacitors (SMD MLCCs)
C1210C226KARALTU	KEMET	获取价格	Surface Mount Multilayer Ceramic Chip Capacitors (SMD MLCCs)
C1210C226M1RALTU	KEMET	获取价格	Surface Mount Multilayer Ceramic Chip Capacitors (SMD MLCCs)
C1210C226M2RALTU	KEMET	获取价格	Surface Mount Multilayer Ceramic Chip Capacitors (SMD MLCCs)

与C1210C226K8RAC相关文章

解析光耦仿真器：升级光耦合器技术的必要性
2024-11-18

35
英伟达新一代Blackwell GPU过热问题致交付延迟
2024-11-18

27
国产厂商思特威CMOS图像传感器芯片单月出货超1亿颗，技术创新引领行业发展
2024-11-14

54
台积电5nm和3nm产能利用率达100%，半导体行业景气度持续攀升
2024-11-14

52

产品中心

服务支持

精选活动

关于我们

帮助中心

C1210C226K8RAC

C1210C226K8RAC 数据手册

与C1210C226K8RAC相关器件

与C1210C226K8RAC相关文章

您还可以找

产品中心

服务支持

精选活动

关于我们

帮助中心

C1210C226K8RAC

C1210C226K8RAC 数据手册

与C1210C226K8RAC相关器件

与C1210C226K8RAC相关文章

您还可以找

您在本页遇到什么问题？