CMOS LDO Regulator Series for Portable Equipments
High-speed
Load Response
FULL CMOS LDO Regulators
BUTA2WNVX Series, BUTA2WHFV Series
No.09020EAT01
●Description
BU□□TA2WNVX /HFV series is high-performance FULL CMOS regulator with 200-mA output, which is mounted on
microminiature package SSON004X1216 (1.2 mm 1.6 mm 0.6 mm) &HVSOF5(1.6mm X 1.6mm X0.6mm). It has
excellent noise characteristics and load responsiveness characteristics despite its low circuit current consumption of 40 A.
It is most appropriate for various applications such as power supplies for logic IC, RF, and camera modules.
Microminiature package SSON004X1216 & HVSOF5 with built-in heatsink is adopted for the package, which contributes to
the space-saving design of the set.
●Features
1) High-accuracy output voltage of 1% (25 mV on 1.5-V & 1.8-V products)
2) High ripple rejection: 70 dB (Typ., 1 kHz, VOUT1.8 V))
3) Compatible with small ceramic capacitor (CIN=Co=1.0 F)
4) Low current consumption: 40 A
5) ON/OFF control of output voltage
6) With built-in overcurrent protection circuit and overheat protection circuit
7) With built-in output discharge circuit
8) Adopting microminiature power package SSON004X1216
●Applications
Battery-powered portable equipment, etc.
Absolute maximum rating
Parameter
Maximum applied power voltage
Symbol
VMAX
Limits
Unit
V
-0.3
~
+6.5
220*1
Power dissipation
Pd1
Pd2
TjMAX
Topr
Tstg
(SSON004X1216)
410*2 (HVSOF5)
+125
mW
mW
°C
°C
°C
Maximum junction temperature
Operational temperature range
Storage temperature range
-40
-55
~
~
+85
+125
*1 When 1 PCB (70 mm 70 mm, thickness 1.6-mm glass epoxy) a standard ROHM board is implemented.
Reduced to 2.2 mW/C when used at Ta=25C or higher.
*2 When 1 PCB (70 mm 70 mm, thickness 1.6-mm glass epoxy) a standard ROHM board is implemented.
Reduced to 4.1 mW/C when used at Ta=25C or higher.
Recommended operating range (Do not exceed Pd.)
Parameter
Input power supply voltage
Maximum output current
Symbol
VIN
IMAX
Limits
~
200
Unit
V
mA
2.5
5.5
Recommended operating conditions
Parameter
Input capacitor
Output capacitor
Symbol
CIN
CO
Min.
0.5*3
0.5*3
Typ.
1.0
1.0
Max.
-
Unit
μF
μF
Conditions
A ceramic capacitor is recommended.
A ceramic capacitor is recommended.
-
*3 Set the capacity value of the capacitor so that it does not fall below the minimum value, taking temperature characteristics,
DC device characteristics, and change with time into consideration.
www.rohm.com
2009.05 - Rev.B
1/27
© 2009 ROHM Co., Ltd. All rights reserved.