™
ANT-2.4-WRT-xxx DATA SHEET
Product Dimensions
Description
The WRT Series antenna is ideally suited for
applications such as wireless vending, security,
traffic, or power equipment which require an
unobtrusive, tamper-resistant antenna solution.
The tiny 19 x 11mm radome installs through a
small hole on the product and is anchored by a
0.75”
(19.0)
threaded base. An adhesive foam compression
ring is used to resist the elements. The 1/2-
0.43”
(11.0)
Adhesive Ring
Remove protective plastic
before installation
wave antenna also features an integral counterpoise, which
eliminates the need for a proximity ground plane. The antenna's
coax feed is available with SMA, RP-SMA, or U.FL terminations.
Alternate coax lengths, connectors and custom colors are
available for volume OEM customers.
SMA or
RP-SMA or U.FL
0.24”
(6.0)
M11x1.0mm
Thread
Features
· Low cost
· Unobtrusive
Counterpoise
· Tamper resistant
· Integral counterpoise
· Indoor / outdoor
· Adhesive or permanent mount
1.28”
(32.5)
0.207”
(5.26)
Electrical Specifications
· Center Freq.
· Recommended Oper. Freq.
· Wavelength
· VSWR
· Impedance
· Connector
2.45GHz
2.4 -2.5GHz
1/2-wave
<1.9 typ. at center
50 ohms
RP-SMA, SMA, or U.FL
RG-174 RP-SMA & SMA
1.32mm U.FL
· Cable
Electrical specifications and plots measured on 24”x 24” reference ground plane
Cable Length
8.50”
Ordering Information
(216.0)
· ANT-2.4-WRT-RPS (with RP-SMA connector)
· ANT-2.4-WRT-SMA (with SMA connector)
· ANT-2.4-WRT-UFL (with U.FL connector)
VSWR Graph
S11 SWR
1.543
CENTER 2 450.000MHz
SPAN 200.000MHz
Typical VSWR
Antenna Factor 159 Ort Lane Merlin, OR 97532 www.antennafactor.com
541-956-0931 (phone) 541-471-6251 (fax)
Rev 6-3-10