Datasheet > AN75

AN75

更新时间： 2024-11-30 12:22:59

品牌	Logo	应用领域
美台 - DIODES		/
页数	文件大小	规格书
12页	552K
描述
High Power Factor LED Replacement T8 Fluorescent Tube

阅读下载

中文翻译

获取价格

如果您发现信息不准确，欢迎纠错

AN75 数据手册

AN75

High Power Factor LED Replacement T8 Fluorescent Tube

using the AL9910 High Voltage LED Controller

Yong Ang, Diodes Inc.

Introduction

This application note describes the principles and design equations required for the design of a high

brightness LED lamp using the AL9910. The equations are then used to demonstrate the design of a

universal, offline, high power factor (PF), 13W LED lamp suitable for use as the replacement for T8

fluorescent tube. A complete design including the electrical diagram, component list and performance

measurements are provided.

AL9910 high power factor buck LED driver

Figure 1 Electrical schematic of a high power factor 13W LED lamp

Figure 1 shows the electrical diagram of an offline 13W LED driver.

On the input side, CX1, CX2, CX3, CX4, L1 and L2 provide sufficient filtering for both differential mode

and common mode EMI noise which are generated by the switching converter circuit.

The rectified AC line voltage from the bridge rectifier DB1 is then fed into a passive power factor

correction or valley fill circuit which consists of 3 diodes and 2 capacitors. D1, D2, D3, C1, C2 improve

the input line current distortion in order to achieve PF greater than 0.9 for the AC line input.

The constant current regulator section consists of a buck converter driven by the AL9910. Normally,

the buck regulator is used in fixed frequency mode but its duty cycle limitation of 50% is not practical

for offline lamp. This problem can be overcome by changing the control method to a fixed off-time

operation.

The design of the internal oscillator in the AL9910 allows the IC to be configured for either fixed

frequency or fixed off-time based on how resistor R_Tis connected. For fixed off-time operation, the

resistor R_Tis connected between the Gate and R_OSCpins, as shown in Figure 1. This converter has

now a constant off-time when the power MOSFET is turned off. The on-time is based on the current

Issue 1 – January 2011

www.diodes.com

12 3 4 5 6 7...12

中文翻译

下载PDF

型号	品牌	获取价格	描述	数据表
AN7500FHQ	PANASONIC	获取价格	aUDIO SIGNAL PROCESSING ic FOR 1.5 v HEADPHONE STEREO
AN7504SB	PANASONIC	获取价格	Pre-amp. and power amp. IC for 1.5 V headphone stereo
AN-7508	FAIRCHILD	获取价格	HVIC/IGBT Half-Bridge Converter Evaluation Circuit
AN7510	PANASONIC	获取价格	BTL Audio Power IC
AN7510S	PANASONIC	获取价格	BTL Audio Power IC
AN7510SH	PANASONIC	获取价格	Audio Amplifier, 1.1W, 2 Channel(s), 1 Func, PDSO56, 0.300 INCH, PLASTIC, HSOP-56
AN7511	PANASONIC	获取价格	1-W BTL audio power amplifier
AN7511S	PANASONIC	获取价格	BTL Audio Power IC
AN7512	PANASONIC	获取价格	BTL Audio Power IC
AN7512S	PANASONIC	获取价格	BTL Audio Power IC