ALED1262ZT
Datasheet
Automotive-grade 12-channel LED driver with open detection, local dimming, bus
driven and standalone operations
Features
•
•
•
•
•
•
•
•
•
•
•
•
•
•
Designed for automotive applications
12 constant current output channels
19 V current generator rated voltage
Output current: from 6 mA to 60 mA
HTSSOP24 exposed pad
Current programmable by a single external resistor
7-bit PWM local brightness control
Slow turn-on/off time, gradual output delay and dithered clock for EMI reduction
Error detection for open LEDs
Supply voltage: from 5.5 V to 38 V
Thermal shutdown and overtemperature alert
Standalone and bus-driven mode
Custom configuration by OTP with Redundancy and ECC
400 kHz fast I²C interface with selectable extended Hamming encoding
Wired-OR error flag connection
Applications
•
•
Automotive rear lights
Automotive interior lighting
Description
The ALED1262ZT is a monolithic 12 output LED driver designed for automotive
exterior and interior lighting applications. The ALED1262ZT guarantees 19 V output
driving capability allowing users to connect several LEDs in series. In the output
stage, twelve regulated current sources provide from 6 mA to 60 mA constant current
to drive LEDs. The current is programmed by a single external resistor. In the
ALED1262ZT, LED open error detection is available.
Maturity status link
ALED1262ZT
Device summary
ALED1262ZT
The brightness can be adjusted separately for each channel through a 7-bit
grayscale control. A slow turn-on and turn-off time improves the system low noise
generation performance. Moreover the gradual output delay reduces the inrush
current. To further increase EMI performance, this device implements an internal
clock dithering to have a spread spectrum noise reduction.
Order code
Package
Packing
ALED1262ZTTR
HTSSOP24 exposed pad
62 parts per tube
Thermal management is equipped with overtemperature data alert and the output
thermal shutdown (170 °C). The I²C high clock frequency, up to 400 kHz, makes the
device suitable for high data rate transmissions. The supply voltage range is between
5.5 V and 38 V avoiding any external pre-regulation or additional load dump
protection on the power supply stage.
2500 parts per reel
This device can operate in bus-driven mode (BDM) using I²C interface or in
standalone mode (SAM) using internal custom configuration by OTP.
DS12631 - Rev 4 - February 2019
For further information contact your local STMicroelectronics sales office.
www.st.com