dBCool® Remote Thermal
Monitor and Fan Controller
ADT7473
FEATURES
GENERAL DESCRIPTION
Controls and monitors up to 4 fans
High and low frequency fan drive signal
The ADT7473 dBCool controller is a thermal monitor and
multiple PWM fan controller for noise sensitive or power
sensitive applications requiring active system cooling. The
ADT7473 can drive a fan using either a low or high frequency
drive signal, monitor the temperature of up to two remote
sensor diodes plus its own internal temperature, and measure
and control the speed of up to four fans so they operate at the
lowest possible speed for minimum acoustic noise.
1 on-chip and 2 remote temperature sensors
Series resistance cancellation on the remote channel
Extended temperature measurement range, up to 191°C
Dynamic TMIN control mode optimizes system acoustics
intelligently
Automatic fan speed control mode controls system cooling
based on measured temperature
Enhanced acoustic mode dramatically reduces user
perception of changing fan speeds
Thermal protection feature via THERM output
Monitors performance impact of Intel® Pentium®4 processor
Thermal control circuit via THERM input
The automatic fan speed control loop optimizes fan speed for a
given temperature. A unique dynamic TMIN control mode
enables the system thermals/acoustics to be intelligently
managed. The effectiveness of the system’s thermal solution can
be monitored using the
input. The ADT7473 also
THERM
provides critical thermal protection to the system using the
bidirectional pin as an output to prevent system or
3-wire and 4-wire fan speed measurement
Limit comparison of all monitored values
Meets SMBus 2.0 electrical specifications
(fully SMBus 1.1 compliant)
THERM
component overheating.
Fully ROHS compliant
FUNCTIONAL BLOCK DIAGRAM
SCL SDA SMBALERT
ADT7473
SERIAL BUS
INTERFACE
PWM
PWM1
REGISTERS
AND
ACOUSTIC
ENHANCEMENT
CONTROL
AUTOMATIC
FAN SPEED
CONTROL
PWM2
PWM3
CONTROLLERS
(HF AND LF)
ADDRESS
POINTER
REGISTER
DYNAMIC
T
MIN
CONTROL
PWM
TACH1
TACH2
TACH3
TACH4
CONFIGURATION
REGISTERS
FAN
SPEED
COUNTER
INTERRUPT
MASKING
PERFORMANCE
MONITORING
INTERRUPT
STATUS
THERMAL
THERM
PROTECTION
REGISTERS
V
TOADT7473
SRC
CC
V
CC
D1+
D1–
D2+
D2–
INPUT
SIGNAL
LIMIT
COMPARATORS
10-BIT
ADC
CONDITIONING
AND
ANALOG
MULTIPLEXER
VALUE AND
LIMIT
REGISTERS
V
CCP
BAND GAP
REFERENCE
BAND GAP
TEMP SENSOR
GND
Figure 1.
Rev. A
Information furnished by Analog Devices is believed to be accurate and reliable. However, no
responsibility is assumed by Analog Devices for its use, nor for any infringements of patents or other
rights of third parties that may result from its use. Specifications subject to change without notice. No
license is granted by implication or otherwise under any patent or patent rights of Analog Devices.
Trademarks and registeredtrademarks arethe property of their respective owners.
One Technology Way, P.O. Box 9106, Norwood, MA 02062-9106, U.S.A.
Tel: 781.329.4700
Fax: 781.461.3113
www.analog.com
©2006 Analog Devices, Inc. All rights reserved.