Quad UV/OV Positive/Negative
Voltage Supervisor
ADM2914
FEATURES
FUNCTIONAL BLOCK DIAGRAM
V
CC
TIMER
Quad UV/OV positive/negative supervisor
Supervises up to 2 negative rails
ADM2914
VH1
Adjustable UV and OV input thresholds
High threshold accuracy over temperature: 1.5%
1 V buffered reference output
TIMER
500mV
500mV
Open-drain
and
reset outputs
OV
UV
VL1
VH2
Adjustable reset timeout with disable option
Outputs guaranteed down to VCC of 1 V
Glitch immunity
UV
62 µA supply current
16-lead QSOP package
VL2
VH3
OUTPUT
LOGIC
APPLICATIONS
500mV
500mV
Server supply monitoring
OV
FPGA/DSP core and I/O voltage monitoring
Telecommunications equipment
Medical equipment
VL3
VH4
MUX
LOGIC
REF
LATCH/DIS
REF
VL4
SEL
GND
Figure 1.
GENERAL DESCRIPTION
the VCC pin to limit the current flow into the VCC pin to no
greater than 10 mA. The ADM2914 uses the internal shunt
regulator to regulate VCC if the supply line exceeds the absolute
maximum ratings.
The ADM2914 is a quad voltage supervisory IC ideally suited
for monitoring multiple rails in a wide range of applications.
Each monitored rail has two dedicated input pins, VHx and VLx,
which allows each rail to be monitored for both overvoltage
(OV) and undervoltage (UV) conditions. A common active low
The ADM2914 is available in two models. The ADM2914-1
offers a latching overvoltage output that can be cleared by
UV
OV
undervoltage ( ) and overvoltage ( ) pin is shared by each
of the monitored voltage rails.
LATCH
toggling the
input pin. The ADM2914-2 has a disable
OV
UV
output
pin that can override and disable both the
signals.
and
The ADM2914 includes a 1 V buffered reference output, REF,
that acts as an offset when monitoring a negative voltage. The
three-state SEL pin determines the polarity of the third and
fourth inputs, that is, it configures the device to monitor
positive or negative supplies.
The ADM2914 is available in a 16-lead QSOP package. The
device operates over the extended temperature range of −40°C
to +125°C.
The device incorporates an internal shunt regulator that enables
the device to be used in higher voltage systems. This feature
requires a resistor to be placed between the main supply rail and
Rev. 0
Information furnished by Analog Devices is believed to be accurate and reliable. However, no
responsibility is assumed by Analog Devices for its use, nor for any infringements of patents or other
rightsof third parties that may result fromits use. Specifications subject to change without notice. No
license is granted by implication or otherwise under any patent or patent rights of Analog Devices.
Trademarks andregisteredtrademarks are the property of their respective owners.
One Technology Way, P.O. Box 9106, Norwood, MA 02062-9106, U.S.A.
Tel: 781.329.4700
Fax: 781.461.3113
www.analog.com
©2009 Analog Devices, Inc. All rights reserved.