5秒后页面跳转
ACS1086SN-TR PDF预览

ACS1086SN-TR

更新时间: 2022-04-23 23:00:11
品牌 Logo 应用领域
意法半导体 - STMICROELECTRONICS 开关
页数 文件大小 规格书
11页 131K
描述
AC switch family Transient voltage protected AC Switch (ACSTM)

ACS1086SN-TR 数据手册

 浏览型号ACS1086SN-TR的Datasheet PDF文件第3页浏览型号ACS1086SN-TR的Datasheet PDF文件第4页浏览型号ACS1086SN-TR的Datasheet PDF文件第5页浏览型号ACS1086SN-TR的Datasheet PDF文件第7页浏览型号ACS1086SN-TR的Datasheet PDF文件第8页浏览型号ACS1086SN-TR的Datasheet PDF文件第9页 
2 AC line switch - basic application  
ACS108-6S  
2
AC line switch - basic application  
The ACS108-6S switch is triggered by a negative gate current flowing from the gate pin G. The  
switch can be driven directly by the digital controller through a resistor as shown in Figure 13.  
Thanks to its overvoltage protection and turn-off commutation performance, the ACS108-6S  
switch can drive a small power high inductive load with neither varistor nor additional turn-off  
snubber.  
Figure 13. Typical application program  
Valve  
AC Mains  
V
MCU  
ss  
Rg  
ACS108-6S  
Power supply  
V
dd  
2.1  
Protection against overvoltage: the best choice is ACS  
In comparison with standard triacs, which are not robust against surge voltage, the ACS108-6S  
is over-voltage self-protected, specified by the new parameter VCL. This feature is useful in two  
operating conditions: in case of turn-off of very inductive load, and in case of surge voltage that  
can occur on the electrical network.  
2.1.1 High inductive load switch-off: turn-off overvoltage clamping  
With high inductive and low RMS current loads the rate of decrease of the current is very low.  
An overvoltage can occur when the gate current is removed and the OUT current is lower than  
IH.  
As shown in Figure 14 and Figure 15, at the end of the last conduction half-cycle, the load  
current decreases (1). The load current reaches the holding current level IH (2), and the ACS  
turns off (3). The water valve, as an inductive load (up to 15 H), reacts as a current generator  
and an overvoltage is created, which is clamped by the ACS (4). The current flows through the  
ACS avalanche and decreases linearly to zero. During this time, the voltage across the switch is  
limited to the clamping voltage VCL. The energy stored in the inductance of the load is  
dissipated in the clamping section that is designed for this purpose. When the energy has been  
dissipated, the ACS voltage falls back to the mains voltage value (5).  
6/11  

与ACS1086SN-TR相关器件

型号 品牌 描述 获取价格 数据表
ACS108-6SUF-TR STMICROELECTRONICS Overvoltage protected AC switch (ACS™)

获取价格

ACS108-8SA STMICROELECTRONICS 过压保护交流开关

获取价格

ACS108-8SN STMICROELECTRONICS 过压保护交流开关

获取价格

ACS108-8TN STMICROELECTRONICS 过压保护交流开关(ACS?)

获取价格

ACS109D INTERSIL Radiation Hardened Dual J-K Flip-Flop with Set and Reset

获取价格

ACS109D/SAMPLE-03 RENESAS AC SERIES, DUAL POSITIVE EDGE TRIGGERED J-K FLIP-FLOP, COMPLEMENTARY OUTPUT, CDIP16, SIDE

获取价格