DATA SHEET
AAT3696
1.6A Li-Ion Battery Charger in a 3x3TDFN Package
Typical Application
IN
VADP
BATT+
BAT
1μF
BATS
OVPFLG
INCHR
OVPFLG
INCHR
10μF
IC
BATT-
LDOOUT
10kΩ
Battery
Pack
2.2μF
AAT3696
STAT
LDOOUT
ISET
2.2μF
EN
ON/OFF
System
MODE
GND
RSET
Pin Descriptions
Pin #
Name
Type
Function
Output of over-voltage protection (OVP) stage and input to battery charger. Decouple to GND
with 2.2μF capacitor.
1
INCHR
I/O
2
3
4
5
IN
I
Input from USB port or AC adapter.
4.9V/30mA LDO output through OVP device. Bypass to GND with 2.2μF capacitor.
Over-voltage fault flag, open drain, active low.
LDOOUT
OVPFLG
STAT
O
O
O
Charge status indicator pin, open drain, active low.
MODE selection pin (internal connect with a 200kꢀ pull-up resistor to INCHR). Factory default
at 10% termination current if MODE is open or connect to INCHR. Continues to charge if
MODE is connect to GND.
6
MODE
I
7
8
9
10
11
12
GND
EN
ISET
IC
BATS
BAT
I/O
I
I
I
I
Power ground.
Active low enable pin (internal connect with a 200kꢀ pull-down resistor).
Connect RSET resistor here to set adaptor or USB charging current.
Internally connected through 100kꢀ resistor to GND. Leave this pin open.
Battery voltage remote sense input.
O
Connect to Li-Ion battery.
Exposed paddle (bottom); The exposed thermal pad (EP) should be connected to board
ground plane and pin 7. The ground plane should include a large exposed copper pad under
the package for thermal dissipation (see package outline).
EP
Pin Configuration
TDFN33-12
(Top View)
1
2
3
4
5
6
12
11
10
9
INCHR
IN
BAT
BATS
IC
LDOOUT
OVPFLG
STAT
ISET
EN
8
7
MODE
GND
Skyworks Solutions, Inc. • Phone [781] 376-3000 • Fax [781] 376-3100 • sales@skyworksinc.com • www.skyworksinc.com
2
201897B
• Skyworks Proprietary Information • Products and Product Information are Subject to Change Without Notice. • April 27, 2012