High Precision Linear Hall-Effect Sensor IC
With an Open Drain Pulse Width Modulated Output
A1356
OPERATING CHARACTERISTICS (continued) Valid over full operating temperature range, TA, VCC = 4.5 to 18 V,
CBYPASS = 0.1 μF, unless otherwise noted
Characteristics
Error Components
Symbol
Test Conditions
Min.
Typ.
Max.
Unit
Linearity Sensitivity Error2,3
Symmetry Sensitivity Error2,3
LinERR
–
–
–
–
±3.0
±1.5
%
%
SymERR
1After powering on the device, output of device needs time to reach valid magnetic response with a valid PWM output.
2See Characteristic Definitions section.
3Guarenteed by design only. Characterized but not tested in production.
4fC varies up to approximately ± 20% over the full operating ambient temperature range, TA, and process.
5Jitter is dependent on the sensitivity of the device.
6Raw device characteristic values before any programming.
7D(Q)(max) is the value available with all programming fuses blown (maximum programming code set). The D(Q) range is the total range from D(Q)(min)
up to and including D(Q)(max). See Characteristic Definitions section.
8Step size is larger than required, in order to provide for manufacturing spread. See Characteristic Definitions section.
9Non-ideal behavior in the programming DAC can cause the step size at each significant bit rollover code to be greater than twice the maximum
specified value of StepD(Q) , StepSENS , or StepfPWM
.
10Overall programming value accuracy. See Characteristic Definitions section.
11Programmed at 150°C and calculated relative to 25°C.
12Sensitivity drift from expected value at TA after programming SENSTC. See Characteristic Definitions section.
Allegro MicroSystems, LLC
115 Northeast Cutoff
5
Worcester, Massachusetts 01615-0036 U.S.A.
1.508.853.5000; www.allegromicro.com