5秒后页面跳转
935285271118 PDF预览

935285271118

更新时间: 2024-11-26 06:25:27
品牌 Logo 应用领域
恩智浦 - NXP 光电二极管
页数 文件大小 规格书
31页 183K
描述
16 I/O, PIA-GENERAL PURPOSE, PDSO24

935285271118 数据手册

 浏览型号935285271118的Datasheet PDF文件第2页浏览型号935285271118的Datasheet PDF文件第3页浏览型号935285271118的Datasheet PDF文件第4页浏览型号935285271118的Datasheet PDF文件第5页浏览型号935285271118的Datasheet PDF文件第6页浏览型号935285271118的Datasheet PDF文件第7页 
PCA9535; PCA9535C  
16-bit I2C-bus and SMBus, low power I/O port with interrupt  
Rev. 05 — 15 September 2008  
Product data sheet  
1. General description  
The PCA9535 and PCA9535C are 24-pin CMOS devices that provide 16 bits of General  
Purpose parallel Input/Output (GPIO) expansion for I2C-bus/SMBus applications and was  
developed to enhance the NXP Semiconductors family of I2C-bus I/O expanders. The  
improvements include higher drive capability, 5 V I/O tolerance, lower supply current,  
individual I/O configuration, and smaller packaging. I/O expanders provide a simple  
solution when additional I/O is needed for ACPI power switches, sensors, push buttons,  
LEDs, fans, etc.  
The PCA9535 and PCA9535C consist of two 8-bit Configuration (Input or Output  
selection), Input, Output and Polarity Inversion (active HIGH or active LOW operation)  
registers. The system master can enable the I/Os as either inputs or outputs by writing to  
the I/O configuration bits. The data for each input or output is kept in the corresponding  
Input or Output register. The polarity of the read register can be inverted with the Polarity  
Inversion register. All registers can be read by the system master. Although pin-to-pin and  
I2C-bus address compatible with the PCF8575, software changes are required due to the  
enhancements and are discussed in Application Note AN469.  
The PCA9535 is identical to the PCA9555 except for the removal of the internal I/O pull-up  
resistor which greatly reduces power consumption when the I/Os are held LOW.  
The PCA9535C is identical to the PCA9535 except that all the I/O pins are  
high-impedance open-drain outputs.  
The PCA9535 and PCA9535C open-drain interrupt output is activated when any input  
state differs from its corresponding Input Port register state and is used to indicate to the  
system master that an input state has changed. The power-on reset sets the registers to  
their default values and initializes the device state machine.  
Three hardware pins (A0, A1, A2) vary the fixed I2C-bus address and allow up to eight  
devices to share the same I2C-bus/SMBus. The fixed I2C-bus address of the PCA9535  
and PCA9535C are the same as the PCA9555 allowing up to eight of these devices in any  
combination to share the same I2C-bus/SMBus.  
2. Features  
I Operating power supply voltage range of 2.3 V to 5.5 V  
I 5 V tolerant I/Os  
I Polarity Inversion register  
I Active LOW interrupt output  
I Low standby current  
I Noise filter on SCL/SDA inputs  

与935285271118相关器件

型号 品牌 获取价格 描述 数据表
935285272118 NXP

获取价格

16 I/O, PIA-GENERAL PURPOSE, PQCC24
935285273112 NXP

获取价格

16 I/O, PIA-GENERAL PURPOSE, PDSO24
935285273118 NXP

获取价格

16 I/O, PIA-GENERAL PURPOSE, PDSO24
935285277112 NXP

获取价格

DATACOM, INTERFACE CIRCUIT, PDSO8
935285277118 NXP

获取价格

DATACOM, INTERFACE CIRCUIT, PDSO8
935285279112 NXP

获取价格

DATACOM, INTERFACE CIRCUIT, PDSO8
935285279118 NXP

获取价格

DATACOM, INTERFACE CIRCUIT, PDSO8
935285281112 NXP

获取价格

DATACOM, INTERFACE CIRCUIT, PDSO8
935285281118 NXP

获取价格

DATACOM, INTERFACE CIRCUIT, PDSO8
935285282112 NXP

获取价格

DATACOM, INTERFACE CIRCUIT, PDSO8