Transient Voltage Suppressors
5.0SMDJ Series
MERITEK
FEATURES
For surface mounted applications in order to optimize board space.
Low profile package.
Built-in strain relief.
Glass passivated junction.
Low inductance.
Excellent clamping capability.
Repetition Rate (duty cycle): 0.01%.
SMC/DO-214AB
Fast response time: typically less than 1.0ps from 0 volt to BV for unidirectional types.
Typical IR less than 1µA.
High Temperature soldering: 260°C/10 seconds at terminals.
MECHANICAL DATA
Case: JEDEC DO-214AB. Molded plastic over glass passivated junction.
Terminal: Solder plated, solderable per MIL-STD-750, Method 2026.
Polarity: Color band denotes cathode except Bidirectional.
Standard Packaging: 16mm tape (EIA STD RS-481).
Weight: 0.007 ounce, 0.21 grams.
MAXIMUM RATINGS AND CHARACTERISTICS
°C
Ratings at 25 ambient temperature unless otherwise specified.
RATING
SYMBOL
PPPM
VALUE
UNIT
Watts
s waveform.
Peak Pulse Power Dissipation on 10/1000
(Note 1, Note 2, Fig. 1)
Minimum 5,000
Peak Pulse Current on 10/1000 s waveform. (Note 1, Fig. 3)
IPPM
Amps
Watts
See Table
6.5
Steady State Power Dissipation at T =75 , Lead length .375”
ꢀꢁ
L
PM(AV)
(9.5mm). (Note 2, Fig. 5)
Peak Forward Surge Current,8.3ms Single Half Sine-Wave
IFSM
300
Amps
Superimposed on Rated Load. (JEDEC Method) (Note 3, Fig. 6)
Operating junction and Storage Temperature Range.
TJ , TSTG
-65 to +150
ꢀꢁ
ꢀꢁ
Notes:ꢀꢀ 1. Non-repetitive current pulse, per Fig. 3 and derated above TA = 25 ꢀꢀꢀꢀꢁer Fig. 2.
2. Mounted on 8.0mm x 8.0mm Copper Pads to each terminal.
3. 8.3ms single half sine-wave, or equivalent square wave, Duty cycle = 4 pulses per minute maximum.
All specifications are subject to change without notice.
1
Rev 7