TPS2375-1
TPS2377-1
www.ti.com
SLVS570–MARCH 2005
This integrated circuit can be damaged by ESD. Texas Instruments recommends that all integrated
circuits be handled with appropriate precautions. Failure to observe proper handling and installation
procedures can cause damage.
ESD damage can range from subtle performance degradation to complete device failure. Precision
integrated circuits may be more susceptible to damage because very small parametric changes could
cause the device not to meet its published specifications.
AVAILABLE OPTIONS
UVLO THRESHOLDS (NOMINAL)
LOW
PACKAGE(1)
TSSOP-8
TA
MARKING
TYPE
HIGH
SO-8
--
802.3af
-40°C to 85°C
30.5 V
30.5 V
39.3 V
35.1 V
TPS2375PW-1
--
2375-1
2377-1
Legacy
TPS2377D-1
(1) Add an R suffix to the device type for tape and reel.
ABSOLUTE MAXIMUM RATINGS
over operating free-air temperature range (unless otherwise noted) (1), voltages are referenced to V(VSS)
TPS237x
VDD, RTN, DET, PG(2)
-0.3 V to 100 V
-0.3 V to 10 V
-0.3 V to 12 V
0 to 515 mA
0 to 5 mA
0 to 1 mA
0 to 50 mA
0 to 1 mA
2 kV
Voltage
ILIM, UVLO
CLASS
RTN(3)
Current, sinking
Current, sourcing
ESD
PG
DET
CLASS
ILIM
Human body model
Charged device model
System level (contact/air) at RJ-45(4)
500 V
8/15 kV
TJ
Maximum junction temperature range
Storage temperature range
Internally limited
-65°C to 150°C
260°C
Tstg
Lead temperature 1,6 mm (1/16 inch) from case for 10 seconds - Green Packages
Lead temperature 1,6 mm (1/16 inch) from case for 10 seconds - Nongreen
Packages
235°C
(1) Stresses beyond those listed under “absolute maximum ratings” may cause permanent damage to the device. These are stress ratings
only, and functional operation of the device at these or any other conditions beyond those indicated under “recommended operating
conditions” is not implied. Exposure to absolute–maximum–rated conditions for extended periods may affect device reliability.
(2) I(RTN) = 0
(3) SOA limited to V(RTN) = 80 V and I(RTN) = 515 mA.
(4) Surges applied to RJ-45 of Figure 1 between pins of RJ-45, and between pins and output voltage rails per EN61000-4-2, 1999.
DISSIPATION RATING TABLE(1)
POWER RATING
TA = 85°C (HIGH-K)
θJA (LOW-K)
°C/W
θJA (HIGH-K)
°C/W
PACKAGE(2)
(mW)
D (SO-8)
238
150
159
266
251
PW (TSSOP-8)
258.5
(1) Tested per JEDEC JESD51. High-K is a (2 signal – 2 plane) test board and low-K is a double-sided
board with minimum pad area and natural convection.
(2) For the most current package and ordering information, see the Package Option Addendum at the
end of this document, or see the TI Web site at www.ti.com.
2