Color Stripe On
16-14 HD Wire
Color Stripe On
16-14 HD Wire
3 Equally Spaced Stripes on Nylon Insulation Restricting
Wire Strip Length
Terminal Splice
Wire
Range
(AWG)
Terminal /Splice
Insulation Color
Code
Crimping
Head
Dot
Code
Insul Dia
Range
Product
Min.
Max.
Min.
Max.
12-10
16-14
---
---
Yellow
PIDG Terminals and Splices
and
PLASTI-GRIP Terminals
7.95
8.74
8.74
9.53
1338317-1
1 Dot
[.313] [.344] [.344] [.375]
Yellow w/Black Stripe
2.41 - 5.08
[.095-.200]
3.02 - 5.08
[.119-.200]
12
10
Yellow w/Yellow Stripe
Yellow w/Brown Stripe
PIDG NYLON
Insulation Restricting
Terminals
9.53 10.31
[.375] [.406]
1338317-1
1 Dot
---
---
NOTE: Refer to Catalog No. 82042 for Product Part Numbers
Figure 2
NOTE
Crimping heads are coated with a preservative to prevent rust and corrosion. Wipe this preservative from the head, particularly
from the crimping surfaces.
Installation
DANGER
To avoid personal injury, ALWAYS disconnect pneumatic tool from air supply before installing the crimping head.
DANGER
DO NOT operate pneumatic tool without the proper crimping head installed. After crimping head is installed, verify the quick
pins are FULLY tightened to avoid personal injury and damage to the tool.
1. Remove quick pins from tool holder (refer to Figure 1).
2. Insert crimping head into tool holder as shown in Figure 1.
3. After crimp head is properly aligned, insert and tighten quick pins provided with the tool holder
assembly.
NOTE
Use Loctite Threadlocker Blue 242 removable threadlocker, or equivalent, to prevent the quick pins from loosening.
4. Connect pneumatic tool to an adequate air supply between 620-690 kPa [90-100 psi]. For specific
information on air line requirements and air hose installation, refer to the customer manual packaged
with the pneumatic power unit.
Removal
DANGER
To avoid personal injury, ALWAYS disconnect pneumatic tool from air supply before removing the crimping head.
Remove quick pins from crimping head; then remove crimping head from tool holder.
Locktite and Threadlocker Blue 242 are trademarks.
2 of 11
Rev B