Series 110
®
Commercial
3
/4
" (19mm)
Diameter, 11/
2
and 2
Watt Wirewound
Variable Resistors
Features
• Inexpensive design
• Open construction
• Four mounting styles
• Incorporated fixed resistor available
• Available with nylon knob
• Interchangeable mounting with
CTS Series 115 preset potentiometer
• RoHS compliant
Electrical and Mechanical Specifications
Resistance Range
Angle of Rotation
1 ohm through 10K ohms (linear taper)
246°±5°without fixed resistor stop
Resistance Tolerance
Standard:±20%
Resistor Adjustment
Standard Cross Slot: Provided in drive plate for screwdriver
adjustment.
Special:±5% or 10%
Special Molded Knob: Available at extra cost secured to
drive plate cross slot.
Power Rating, Watts
2 watts @ 55°C derated to no load @ 105°C,
mounted on steel panel
Mounting Types Available
1.5 watts @ 55°C derated to no load @ 105°C,
mounted on bakelite panel
Type 110:
Solder or clinch-ear mounted
Type XPC - 110: Vertically mounted on printed circuit board
Type 111:
Type 112:
Snap-in mounting
Eyelet or rivet mounting
Voltage Rating
Determined by resistance value and wattage rating
Rotational Torque
Resistance Taper
1/2 to 10 inch ounces (36 – 720 gf-cm)
Standard:Linear taper only
Terminals
Minimum Resistance
Terminals at end of CW or CCW rotation may be omitted.
Refer to terminals on all types by numbers 1 and 3 as
indicated on line drawings.
At ends of rotation: 1% or 1 ohm, whichever is greater
Resistance Taper
None
Incorporated Fixed Resistor
A fixed resistor can be incorporated in the Series 110
at the end of CW or CCW rotation to a minimum of 10%
of the total resistance. The rotation is shortened by an
amount proportional to the ratio of the fixed resistor to
the total resistance. Available at extra cost.
1 - 3
© 2006 CTS Corporation. All rights reserved. Information subject to change.
9/30/06
CTS Electronic Components
www.ctscorp.com