ZMM 1 … ZMM 100 ( 500mW )
Surface mount
Non-Planar Silicon Zener Diodes
Nicht-Planare Silizium Zener-Dioden
für die Oberflächenmontage
Nominal Zener voltage
Nominale Zener-Spannung
1…100 V
Standard tolerance of Zener voltage
Standard-Toleranz der Zener Spannung
.± 5 % (E24)
Plastic case MiniMELF
SOD-80
Kunststoff-Gehäuse MiniMELF
DO-213AA
Weight approx. – Gewicht ca.
0.04 g
Standard packaging taped and reeled
Standard Lieferform gegurtet auf Rolle
see page 18
siehe Seite 18
Dimensions / Maße in mm
Marking:
One blue ring denotes “cathode” and “Z-Diode family ”
The type numbers are noted only on the lable on the reel
Ein blauer Ring kennzeichnet “Kathode” und “Z-Dioden-Familie ”
Die Typenbezeichnungen sind nur auf dem Rollenaufkleber vermerkt
Kennzeichnung:
Maximum ratings and Characteristics
Grenz- und Kennwerte
500mW 1)
Power dissipation – Verlustleistung
TA = 50 /C
Ptot
Standard Zener voltage tolerance is graded to the international E 24 standard (about ± 5%).
Other voltage tolerances and Zener voltages on request.
Die Standard-Toleranz der Zener-Spannung ist gestuft nach der internationalen Reihe E 24
(entspricht etwa ± 5%). Andere Toleranzen oder Zener-Spannungen auf Anfrage.
Operating junction temperature – Sperrschichttemperatur
Storage temperature – Lagerungstemperatur
Tj
TS
– 50...+175/C
– 50...+175/C
Thermal resistance junction to ambient air
RthA < 170 K/W 1)
Wärmewiderstand Sperrschicht – umgebende Luft
Thermal resistance junction to terminal
RthT
< 70 K/W
Wärmewiderstand Sperrschicht - Kontaktfläche
1) Mounted on P.C. board with 25 mm2 copper pads at each terminal
Montage auf Leiterplatte mit 25 mm2 Kupferbelag (Lötpad) an jedem Anschluß
2) Tested with pulses – Gemessen mit Impulsen
3) The ZMM 1 is a diode operated in forward. Hence, the index of all parameters should be “F” instead of “Z”.
The cathode, indicated by the blue ring is to be connected to the negative pole.
Die ZMM 1 ist eine in Durchlaß betriebene Si-Diode. Daher ist bei alle Kenn- und Grenzwerten der Index
“F” anstatt “Z” zu setzten. Die durch den blauen Ring gekennzeichnete Kathode ist mit dem Minuspol zu verbinden.
1
15.02.2001
F:\Data\Wp\DatBlatt\Einzelblätter\zmm1..100-nicht-planar-plastik.wpd