Approval sheet
TEST AND REQUIREMENTS (JIS C 5201-1 : 1998)
REQUIREMENT
Resistor
TEST
PROCEDURE / TEST METHOD
0
DC resistance values measured at the test voltages specified
below :
DC resistance
Within the specified
tolerance
Clause 4.5
<50m
<10@0.1V, <100@0.3V, <1K@1.0V,
<10K@3V, <100K@10V, <1M@25V, <10M@30V
Natural resistance change per change in degree centigrade. Refer to
Temperature Coefficient
of Resistance(T.C.R)
“QUICK REFERENCE DATA”
R2 R
106 (ppm/C) t1 : 20°C+5°C-1°C
1
Clause 4.8
N/a
R
1t2 t1
R1 : Resistance at reference temperature
R2 : Resistance at test temperature
Short time overload
(S.T.O.L)
Permanent resistance change after a 2 second application
of a voltage 2.5 times RCWV or the maximum overload
voltage specified in the above list, whichever is less.
R/R max. (1%+0.05)
<50m
<50m
Clause 4.13
Un-mounted chips completely immersed for 10±0.5second
in a SAC solder bath at 260℃±5ºC
Resistance to soldering
heat(R.S.H)
ΔR/R max. ±(1%+0.05Ω)
no visible damage
IEC 60068-2-58: 2004
Solderability
95% coverage min., good tinning and no
visible damage
Un-mounted chips completely immersed for 2±0.3second in
a SAC solder bath at 235℃±5℃
IEC 60068-2-58: 2004
30 minutes at -55C3C, 2~3 minutes at 20°C+5°C-1°C, 30
minutes at +125C3C, 2~3 minutes at 20°C+5°C-1°C,
total 5 continuous cycles
Temperature cycling
R/R max. (1%+0.05)
< 50m
< 50m
Clause 4.19
1000+48/-0 hours, loaded with RCWV or Vmax in humidity
chamber controller at 40C2C and 90~95% relative
humidity,
R/R max. (5%+0.10)
Damp Heat
no visible damage
(Load life in humidity)
Clause 4.24
1000+48/-0 hours; loaded with RCWV or Vmax in chamber
R/R max. (5%+0.10)
Load Life (Endurance)
< 50m
< 50m
no visible damage
controller 70±2ºC, 1.5 hours on and 0.5 hours off
Clause 4.25
125ºC, no load, 1000 hours
R/R max. (5%+0.10)
Endurance at the upper
category temperature
no visible damage
Resistors mounted on a 90mm glass epoxy resin PCB(FR4), No visual damage,
Bending strength
< 50m
bending once 3mm for 10sec.
R/R max. (1%+0.05)
No visual damage
Clause 4.33
Adhesion
Pressurizing force: 2N, Test time: 10±1sec.
Clause 4.32
Page 6 of 8
ASC_WR01X_V06
JAN - 2017