WL50S Stainless Steel High-Intensity Work
Spot Light
Datasheet
Chemically Resistant LED work lighting
•
•
•
•
•
•
•
Three lens options, depending on model, to vary spot size
Illuminates a large area with an even pattern of light and no shadows
12 to 30 V dc operation
56 mm (2.2 in) diameter with flat profile and 30 mm (1.2 in) mounting base
®
Rugged, Viton o-ring sealed housing rated to IP69K
Chemically resistant 316 stainless steel housing for use in harsh environments
FDA grade silicone gasket
WARNING: Not To Be Used for Personnel Protection
Never use this device as a sensing device for personnel protection. Doing so could lead to
serious injury or death. This device does not include the self-checking redundant circuitry necessary
to allow its use in personnel safety applications. A sensor failure or malfunction can cause either an
energized or de-energized sensor output condition.
Models
Lux
Lens Angle (see
Beam Patterns
on page 2)
Model
LED Color
Window Material
Lumens
Connection
0.5 m
1 m
WL50SWSSL5Q
WL50SWSSGL5Q
Polycarbonate
Glass
±5°
295
13780
3445
small, more
focused spot
5 pin Euro integral QD
connector (use with a 4-
wire or 5-wire mating
cordset, only 2 wires used
for connection)
White,
WL50SWSSL11Q
WL50SWSSGL11Q
WL50SWSSL20Q
WL50SWSSGL20Q
Polycarbonate
Glass
±11°
285
270
5460
2000
1365
500
5000–8300 K
larger spot
Polycarbonate
Glass
±20°
largest spot
Specifications
Supply Voltage and Current
Environmental Rating
IEC IEC IP67, IEC IP69K per DIN 40050-9
Operating Voltage: 12 to 30 V dc
Current Draw: 400 mA maximum
NOTE: Do not spray the cable with a
Supply Protection Circuitry
high-pressure sprayer or cable damage
will result.
Protected against reverse polarity and transient voltages
Light Source
Three high-intensity LEDs; see models table for color temperature
Useful Life
Operating Conditions
–20 °C to +50 °C (–4 °F to +122 °F)
95% maximum relative humidity (non-condensing)
When operating within specifications, output will decrease less than
30% after 50,000 hours.
Vibration and Mechanical Shock
Construction
All models meet Mil. Std. 202F requirements method 201A (vibration:
10 to 60 Hz max., double amplitude 0.06", maximum acceleration
10G). Also meets IEC 947-5-2; 30G 11 ms duration, half sine wave.
316 stainless steel housing, polycarbonate or glass window with Viton
seal, 316 stainless steel M30 mounting nut, FDA grade silicon base
gasket
Storage Temperature
Mounting
−40 °C to +70 °C (−40 °F to +158 °F)
95% maximum relative humidity (non-condensing)
30 × 1.5 mm thread base mount
Connections
Certifications
Integral 5-pin M12 quick disconnect fitting; 4-pin connecting cordset
required for quick disconnect fitting models; only 2 wires used
Approvals are pending
Original Document
168649 Rev. D
19 December 2016
168649