ADSemiconductor®
TSD1007RM12 (Resistive Multi Touch Screen Controller)
2.2 SCL, SDA Implementation
VDD
RSCL
RSDA
SCL
SDA
SCL <<
SDA <<
SCL and SDA connect Pull-up resistance as above figure.
SDA as an Open Drain Port should connect Pull-up resistance, SCL as an Input Port can be
used by eliminating Pull-up resistance. (I2C slave address is 0xA0)
2.3 INT Implementation
VDD
RINT
INT
INT <<
INT shall connect pull- up resistance as above figure.
INT as Open Drain Port works Low active when touching.
2.4 RESET Implementation
TSD1007RM12 has internal data latches. So, initial state of these latches must be reset by
external reset pulse before normal operation starts. The reset pulse can be controlled by host
MCU directly or other reset device. If not, the circuit should be composed as below figure. The
reset pulse must have high pulse duration about a few msec to cover power VDD rising time.
The recommended value of RRST and CRST are 330KΩ and 100nF.
VDD
After Power Stable
3.3V
CRST
RESET <<
Power
Reset
RRST
27.4us(Max) 20us(Min) 27.4us(Max)
Recommended reset circuits 1
Reset Timing Chart
ADSemiconductor Confidential
5 / 15