150W TRV-150 Series
Switch Mode LED Drivers
Constant Voltage
Aluminum Housing
Electrical Specifications
Input Voltage Range:
100 - 277 Nom. Vac (90 - 305 V Min/Max)
Frequency:
50/60 Hz Nom. (47-63 Hz Min/Max)
0.90 @ 75-100% load, 100-277V
<_ 20% @ 75-100% load, 100-277V
Power Factor:
THD:
Inrush Current:
Input Current:
Maximum Power:
Line Regulation:
Load Regulation:
Leakage Current:
Typical Efficiency
Turn-on Delay:
Ripple and Noise:
Protection:
65 Amps maximum @ 230 Vac, cold start 25ºC
1.75 A max 100Vac, 0.8 A max 220Vac
150W
± 1%
± 2%
1 mA 277 Vac 60Hz
92.5%-93.5% at 220Vac
0.9S typical 110Vac, 0.5S typical 220Vac
2% Vo
• Total Power: 150 Watts
• Input Voltage: 100-277 Vac Nom.
• UL Dry & Damp Location Rated
• IP67
Over-Voltage (latch mode), Over-Temperature (110°C),
Over-Current (hiccup mode), Lightning, and
Short Circuit Protection with Self Recovery
• Ultra-high Efficiency
• High Power Factor
• UL8750
Environmental Specifications
Minimum Starting Temp: -35ºC
Maximum Case Temp.
Storage Temperature:
Humidity:
90°C
-40ºC to +85ºC
5% to 100%
Convection
Class A
Cooling:
Sound Rating:
MTBF:
260,000 Hours @ 110Vac input, 80% load and 25ºC
ambient conditions per MIL-HDBK-217F
Lifetime:
Weight:
77,200 Hours @ 220Vac, 80% load and Tc=60ºC
2.2 lbs. (1.0 kg)
Output Voltage Output Current Max. Output
Typical
Efficiency
Model Number
New Surge Protection and HI-POT Testing
(Vdc ±5%)
Range (mA)
Power (W)
TRV-150S012ST
TRV-150S020ST
TRV-150S024ST
TRV-150S036ST
TRV-150S048ST
TRV-150S054ST
12
20
24
36
48
54
0-12.5
150
92%
92%
93%
93%
93%
93%
0-7.50
150
0-6.25
150
0-4.17
150
Metal Lock Sheet
0-3.13
150
Nut
0-2.78
150
Safety and EMC Compliance
UL8750, Compliance to UL1012, UL935,
CAN/CSA-C22.2 No. 0, CSA-C22.2 No. 107.1-01, CSA-C22.2 No. 250.0
HI-POT Test
Normal Application
UL/CUL
The new design of this LED driver provides 1.4KV surge protection. To properly
HI-POT test this unit, the surge protection must be disconnected. The screw, nut, and
metal lock sheet on the input side of the driver provide for this. To test, first remove
the nut and lock sheet as shown. After testing, secure the nut and lock sheet to
provide line-to-earth protection.
C E
EN 61347-1, EN61347-2-13
EN 55015
Conducted emission Test & Radiated emission Test
EN 61000-3-2 Harmonic current emissions
This HI-POT test feature is available on product manufactured after August 15, 2015.
EN 61000-3-3 Voltage fluctuations & flicker
EN 61000-4-2 Electrostatic Discharge (ESD): 8 kV air discharge, 4 kV contact discharge
EN 61000-4-3 Radio-Frequency Electromagnetic Field Susceptibility Test-RS
EN 61000-4-4 Electrical Fast Transient / Burst-EFT
EN 61000-4-5 Surge Immunity Test: AC Power Line: line to line 4 kV, line to earth 6 kV
EN 61000-4-6 Conducted Radio Frequency Disturbances Test-CS
EN 61000-4-8 Power Frequency Magnetic Field Test
E332160
EN 61000-4-11 Voltage Dips
Note:
EN 61547
Electromagnetic Immunity Requirements Applies to Lighting Equipment
LED drivers are designed and intended to operate LED loads only.
Non-LED loading may be outside the specified design limits of our
LED drivers, and therefore cannot be covered by any warranty.
If you desire to use our LED drivers to operate non-LED loads
please contact us to discuss compatibility.
Specifications subject to change without notice.
Rev 8-28-15
Thomas Research Products • 1225 Bowes Rd • Elgin, IL 60123 • T 847-515-3057 • F 847-515-3047 • www.trpssl.com