TP3054-X, TP3057-X
www.ti.com
SNOSBY2C –MARCH 2005–REVISED APRIL 2013
Extended Temperature Serial Interface CODEC/Filter COMBO Family
Check for Samples: TP3054-X, TP3057-X
1
FEATURES
DESCRIPTION
The TP3054, TP3057 family consists of μ-law and A-
law monolithic PCM CODEC/filters utilizing the A/D
and D/A conversion architecture shown in Figure 3,
2
•
•
−40°C to +85°C Operation
Complete CODEC and Filtering System
(COMBO) Including:
and
a serial PCM interface. The devices are
–
–
Transmit High-Pass and Low-Pass Filtering
fabricated using TI's advanced double-poly CMOS
process (microCMOS).
Receive Low-Pass Filter with Sin x/x
Correction
The encode portion of each device consists of an
input gain adjust amplifier, an active RC pre-filter
which eliminates very high frequency noise prior to
entering a switched-capacitor band-pass filter that
rejects signals below 200 Hz and above 3400 Hz.
–
–
Active RC Noise Filters
μ-Law or A-Law Compatible COder and
DECoder
–
–
–
Internal Precision Voltage Reference
Serial I/O Interface
Also included are auto-zero circuitry and
a
companding coder which samples the filtered signal
and encodes it in the companded μ-law or A-law
PCM format. The decode portion of each device
consists of an expanding decoder, which reconstructs
the analog signal from the companded μ-law or A-law
code, a low-pass filter which corrects for the sin x/x
response of the decoder output and rejects signals
above 3400 Hz followed by a single-ended power
amplifier capable of driving low impedance loads. The
devices require two 1.536 MHz, 1.544 MHz or
2.048 MHz transmit and receive master clocks, which
may be asynchronous; transmit and receive bit
clocks, which may vary from 64 kHz to 2.048 MHz;
and transmit and receive frame sync pulses. The
timing of the frame sync pulses and PCM data is
compatible with both industry standard formats.
Internal Auto-Zero Circuitry
•
•
•
•
•
•
•
•
•
•
•
μ-Law, 16-Pin - TP3054
A-Law, 16-Pin - TP3057
Designed for D3/D4 and CCITT Spplications
±5V Operation
Low Operating Power - Typically 50 mW
Power-Down Standby Mode - Typically 3 mW
Automatic Power-Down
TTL or CMOS Compatible Digital Interfaces
Maximizes Line Interface Card Circuit Density
Dual-In-Line or PCC Surface Mount Packages
See also AN-370, “Techniques for Designing
with CODEC/Filter COMBO Circuits”
(SNLA136)
Connection Diagram
Figure 1. Plastic Chip Carriers (Top View)
Figure 2. Dual-In-Line Package (Top View)
Package Number NFG001E & DW0016B
Package Number FN0020A
1
Please be aware that an important notice concerning availability, standard warranty, and use in critical applications of
Texas Instruments semiconductor products and disclaimers thereto appears at the end of this data sheet.
All trademarks are the property of their respective owners.
2
PRODUCTION DATA information is current as of publication date.
Products conform to specifications per the terms of the Texas
Instruments standard warranty. Production processing does not
necessarily include testing of all parameters.
Copyright © 2005–2013, Texas Instruments Incorporated