TLP117
Absolute Maximum Ratings (Ta=25°C)
Characteristic
Forward current
Symbol
Rating
25
Unit
mA
I
F
Forward current derating (Ta≥85°C)
Peak transient forward current (Note 1)
Reverse voltage
ΔIF/ΔTa
-0.7
1
mA/°C
A
I
FPT
V
6
V
R
O
Output current
I
10
mA
Output voltage
V
6
6
V
V
O
Supply voltage
V
CC
Output power dissipation
Operating temperature range
Storage temperature range
P
40
mW
°C
°C
O
T
opr
-40 to 105
-55 to 125
T
stg
sol
Lead solder temperature(10s)
T
260
°C
Isolation voltage
BVs
3750
Vrms
(AC,1min.,R.H.≤60%,Ta=25°C)
(Note 2)
Note: Using continuously under heavy loads (e.g. the application of high temperature/current/voltage and the
significant change in temperature, etc.) may cause this product to decrease in the reliability significantly even
if the operating conditions (i.e. operating temperature/current/voltage, etc.) are within the absolute maximum
ratings.
Please design the appropriate reliability upon reviewing the Toshiba Semiconductor Reliability Handbook
(“Handling Precautions”/“Derating Concept and Methods”) and individual reliability data (i.e. reliability test
report and estimated failure rate, etc).
Note 1: Pulse width PW≤1μs,300 pps.
Note 2: This device is regarded as a two-terminal device: pins 1 and 3 are shorted together, and pins 4,5 and 6 are
shorted together.
Recommended Operating Conditions
Characteristic
Input current , ON
Symbol
Min
10
0
Typ.
—
Max
16
Unit
mA
V
I
F(ON)
—
Input voltage , OFF
Supply voltage(*)
V
1.0
5.5
F(OFF)
(Note 3)
4.5
5.0
V
V
CC
* This item denotes operating ranges, not meaning of recommended operating conditions.
Note : Recommended operating conditions are given as a design guideline to obtain expected performance of the
device. Additionally, each item is an independent guideline respectively. In developing designs using this
product, please confirm specified characteristics shown in this document.
Note 3 : The detector of this product requires a power supply voltage (V ) of 4.5 V or higher for stable operation. If
CC
V
is lower than this value, I
may increase or the output may be unstable.
CC
CC
Be sure to use the product after checking the supply current, and the operation of a power-on/-off.
2
2010-04-02