5秒后页面跳转
TEA1104 PDF预览

TEA1104

更新时间: 2024-01-17 07:27:17
品牌 Logo 应用领域
恩智浦 - NXP 电池
页数 文件大小 规格书
16页 123K
描述
Cost effective battery monitor and fast charge IC for NiCd and NiMH chargers

TEA1104 技术参数

生命周期:Obsolete包装说明:SOP,
Reach Compliance Code:unknownECCN代码:EAR99
HTS代码:8542.39.00.01风险等级:5.71
可调阈值:NO模拟集成电路 - 其他类型:POWER SUPPLY SUPPORT CIRCUIT
JESD-30 代码:R-PDSO-G8长度:4.9 mm
信道数量:2功能数量:1
端子数量:8封装主体材料:PLASTIC/EPOXY
封装代码:SOP封装形状:RECTANGULAR
封装形式:SMALL OUTLINE认证状态:Not Qualified
座面最大高度:1.75 mm最大供电电压 (Vsup):11.5 V
最小供电电压 (Vsup):5.45 V表面贴装:YES
技术:BICMOS端子形式:GULL WING
端子节距:1.27 mm端子位置:DUAL
宽度:3.9 mmBase Number Matches:1

TEA1104 数据手册

 浏览型号TEA1104的Datasheet PDF文件第1页浏览型号TEA1104的Datasheet PDF文件第2页浏览型号TEA1104的Datasheet PDF文件第3页浏览型号TEA1104的Datasheet PDF文件第5页浏览型号TEA1104的Datasheet PDF文件第6页浏览型号TEA1104的Datasheet PDF文件第7页 
Philips Semiconductors  
Objective specification  
Cost effective battery monitor and fast  
charge IC for NiCd and NiMH chargers  
TEA1104; TEA1104T  
PINNING  
SYMBOL  
PIN  
DESCRIPTION  
GND  
NTC  
1
2
ground  
handbook, halfpage  
GND  
NTC  
1
2
3
4
8
7
6
5
LED  
negative temperature coefficient  
resistor input  
OSC  
TEA1104  
VS  
3
4
5
6
7
8
stabilized supply voltage  
battery voltage sensing  
reference resistor  
positive supply voltage  
oscillator input  
V
P
V
s
Vbat  
Rref  
VP  
R
V
ref  
bat  
MGE353  
OSC  
LED  
Fig.2 Pin configuration.  
LED output  
Trickle charge is active if:  
– battery full is detected  
INTRODUCTION  
The operation of the TEA1104; TEA1104T is explained  
with the aid of the application diagram illustrated in Fig.7.  
– maximum time is exceeded  
– maximum cut-off temperature is exceeded after the  
initial phase.  
An application note (AN95085) is available describing the  
versatility of the TEA1104; TEA1104T.  
An external power current source charges the batteries via  
an electronic switch which is controlled by the TEA1104.  
The TEA1104 monitors the battery voltage. Fully charged  
batteries are detected when the battery voltage peaks. In  
fact, a voltage drop of 0.25% with respect to the top value  
is detected. Fast charging is initiated at ‘power on’ or at  
‘replaced batteries’. The switch is continuously on,  
providing that all protection levels are met. At battery full  
detection, the charge current is duty cycled to reduce the  
average charge current to a lower level, keeping the  
batteries fully charged but at he same time assuring long  
battery life. In Fig.3 the battery voltage during fast charge  
is plotted.  
Supply block  
For correct start-up, the IC supply current is limited to  
35 µA (typ.) until the start-up voltage of 6.4 V is reached  
(standby mode). Thereafter, the operating supply voltage  
VP has to be within the window of 5.45 to 11.5 V, meaning  
that there is no need for an external voltage regulator to  
supply the IC.  
The supply block delivers the following outputs:  
With the help of an external resistor (pin Rref), a  
reference current is obtained which defines the  
accuracy of all IC timing characteristics  
Externally available 4.25 V stabilized voltage source  
(Vsource). This source is used internally to supply a large  
part of the circuit and can be used to set the NTC biasing  
and to supply other external circuitry with a maximum  
current of 1 mA. Protection information is provided via  
VS, to design a dual LED indicator  
FUNCTIONAL DESCRIPTION  
A block diagram of the TEA1104; TEA1104T is illustrated  
in Fig.1  
Mode latch  
Power-on reset pulse resets all digital circuitry after a  
start or restart, due to an interrupted VS.  
The Mode latch determines if the system is in the fast or in  
the slow charge mode.  
Fast charge is active at:  
– power switch-on and battery connected  
– temperature between minimum and maximum value  
– battery insert  
1996 Feb 26  
4

与TEA1104相关器件

型号 品牌 获取价格 描述 数据表
TEA1104P NXP

获取价格

暂无描述
TEA1104T NXP

获取价格

Cost effective battery monitor and fast charge IC for NiCd and NiMH chargers
TEA1104TD-T ETC

获取价格

Battery Management
TEA1104T-T NXP

获取价格

IC 2-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO8, Power Management Circuit
TEA1110 NXP

获取价格

Low voltage versatile telephone transmission circuit with dialler interface
TEA1110A NXP

获取价格

Low voltage versatile telephone transmission circuit with dialler interface
TEA1110A UTC

获取价格

LOW VOLTAGE VERSATILE TELEPHONE TRANSMISSION TELEPHONE TRANSMISSION INTERFACE
TEA1110A(14DIP) UTC

获取价格

Telephone Circuit, Bipolar, PDIP14
TEA1110A(14SOP) UTC

获取价格

Telephone Circuit, Bipolar, PDSO14
TEA1110A_10 UTC

获取价格

LOW VOLTAGE VERSATILE TELEPHONE TRANSMISSION CIRCUIT WITH DIALLER INTERFACE