5秒后页面跳转
TDA8742H PDF预览

TDA8742H

更新时间: 2024-02-04 18:24:42
品牌 Logo 应用领域
恩智浦 - NXP 消费电路商用集成电路接收器集成电路
页数 文件大小 规格书
21页 284K
描述
Satellite sound circuit with noise reduction

TDA8742H 技术参数

生命周期:Obsolete包装说明:QFP,
Reach Compliance Code:unknown风险等级:5.7
商用集成电路类型:AUDIO DEMODULATOR解调类型:FM
谐波失真:0.1%JESD-30 代码:S-PQFP-G44
长度:10 mm功能数量:1
端子数量:44最高工作温度:70 °C
最低工作温度:-20 °C封装主体材料:PLASTIC/EPOXY
封装代码:QFP封装形状:SQUARE
封装形式:FLATPACK认证状态:Not Qualified
座面最大高度:2.1 mm信噪比Nom(FM):70 dB
最大压摆率:45 mA最大供电电压 (Vsup):13.2 V
最小供电电压 (Vsup):8 V表面贴装:YES
温度等级:COMMERCIAL端子形式:GULL WING
端子节距:0.8 mm端子位置:QUAD
宽度:10 mmBase Number Matches:1

TDA8742H 数据手册

 浏览型号TDA8742H的Datasheet PDF文件第5页浏览型号TDA8742H的Datasheet PDF文件第6页浏览型号TDA8742H的Datasheet PDF文件第7页浏览型号TDA8742H的Datasheet PDF文件第9页浏览型号TDA8742H的Datasheet PDF文件第10页浏览型号TDA8742H的Datasheet PDF文件第11页 
Philips Semiconductors  
Product specification  
Satellite sound circuit with noise reduction  
TDA8742; TDA8742H  
High frequency components in the amplified PLL output  
signal are filtered out in the audio LPF block (4th order  
Butterworth low-pass filter) to prevent unwanted influence  
on the noise reduction.  
ABBREVIATIONS  
fMOD = modulating frequency.  
fM = frequency deviation of the main Channel.  
fS1 = frequency deviation of secondary Channel 1 (left).  
fS2 = frequency deviation of secondary Channel 2 (right).  
fOM = carrier frequency of main Channel.  
fOS1 = carrier frequency of secondary Channel 1.  
fOS2 = carrier frequency of secondary Channel 2.  
LPF = Low-Pass Filter.  
NOISE REDUCTION (NR)  
The noise reduction can be regarded as an input  
level-dependent low-pass filter (adaptive de-emphasis  
system) followed by a fixed de-emphasis. With maximum  
input level (0 dB) the frequency response of the first part  
(i.e. without the fixed de-emphasis) is virtually flat. As the  
input level is lowered by x-dB, the higher output  
frequencies will be reduced an extra x-dB with respect to  
the lower frequencies (1 : 2 expansion).  
NR = Noise Reduction.  
The NR output signal is fed to pin 36 (32) (left) and pin 32  
(28) (right) via an internal resistor.  
PLL = Phase-Locked-Loop.  
Fixed de-emphasis is achieved by these resistors and  
external capacitors connected to ground. The signals are  
DC decoupled via pins 36/35 (32/31) and 32/33 (28/29)  
and then routed to the output selectors.  
OUTPUT SELECTION  
With the output selector (see Table 2) the outputs at  
pins 25 and 24 (21 and 20) can be switched to the different  
channels. Both outputs can be switched to both secondary  
channels, to the main channel and to the external inputs at  
pin 28 and 27 (24 and 23) for IC chaining purposes.  
Pin 23 (19) is a separate output which delivers the main  
channel only, thereby creating the possibility of having  
three different output channels simultaneously e.g. for use  
in hi-fi VCRs.  
The outputs at pins 25 and 24 (21 and 20) can be muted  
by setting the MUTE signal at pin 13 (8) to logic 1 (switch  
positions 6 and 7).  
The output at pin 23(19) can be muted by setting the  
MUTE signal and the EXT/INT signal at pin 26 (22) both  
logic 1 (switch position 7).  
All outputs at pins 23, 24 and 25 (19, 20 and 21) are line  
drivers with SCART level capability and are short-circuit  
protected by 125 output resistors.  
Output level of all channels = 6 dBV typical when  
frequency deviation of FM signal is 54% of maximum  
frequency deviation (i.e. 0.54 × 85 kHz = 46 kHz for the  
main channel and 0.54 × 50 kHz = 27 kHz for the  
secondary channels) at 1 kHz modulation frequency  
(reference level).  
October 1994  
8

与TDA8742H相关器件

型号 品牌 描述 获取价格 数据表
TDA8745 NXP Satellite sound receiver with I2C-bus control

获取价格

TDA8745H NXP Satellite sound receiver with I2C-bus control

获取价格

TDA8745HB-S ETC TV/Video Sound Circuit

获取价格

TDA8745H-T NXP 暂无描述

获取价格

TDA8745N NXP IC SPECIALTY CONSUMER CIRCUIT, PDIP42, Consumer IC:Other

获取价格

TDA8751T NXP QPSK receiver

获取价格