SVFA0510SG Series
6.0 TECHNICAL NOTES
Please note that many of these functions are also demonstrated in detail on the VPT website in the
form of technical video labs.
6.1 GENERAL INFORMATION
6.1.1 Topology Description
The SVFA0510SG is a non-isolated, fixed-frequency, radiation-hardened, synchronous buck
converter. It operates from a 5 V input and provides a stepped-down, precisely regulated, programmable output voltage at high
efficiency. The SVFA0510SG is optimized for low voltage point-of-load (POL) applications.
6.1.2 External Components
The SVFA0510SG Series has internal input and output capacitors. To meet the performance specifications in Section 3.2, a minimum
additional 100 µF tantalum input decoupling capacitor is required. The SVFA0510SG is stable with no load capacitance. Additional
output capacitance is allowed up to the maximum listed in Section 3.2.
6.1.3 Source Impedance
The impedance of the 5V input source can interact with the POL converter and can affect performance. High source impedance is often
caused by a long input cable or other components added in series with the input. In some cases, additional input capacitance will be
needed to stabilize the system.
6.1.4 Case Connection
The SVFA0510SG case is connected to GND at a single point inside of the package.
6.2 FUNCTION DESCRIPTIONS
VIN
6.2.1 On/Off Control (Inhibit)
47K
The INH (Inhibit) pin is a control pin referenced to GND. The INH pin must be driven
using an open-collector or open-drain configuration. Pulling the INH pin low disables
INH
the converter output. Leaving INH open enables the output, allowing the converter to
operate normally. The pin must be pulled below 1.5V to disable the output. An
OPTIONAL
CAPACITOR
optional capacitor from INH to GND may be used to delay turn-on. The INH pin should
be left open if not used.
GND
Sales Information
Phone:(425) 353-3010
Fax: (425) 353-4030
SVFA0510SG - 3.0
Page 7
E-mail: vptsales@vptpower.com
Web: www.vptpower.com